Re: TNC3S
Ray Wells schreef:
Peter wrote:
Hi
I'am looking for support to get a TNC3S with 2 modem working
With standard kissattach I got modem 1 on the air.
In the ax25 how-to I found:
If you have a dual port tnc and it is connected to
your /dev/ttyS0 serial device at 9600 bps,
the command:
/usr/sbin/mkiss -s 9600 /dev/ttyS0 /dev/ptyp0 /dev/ptyp1
/usr/sbin/kissattach /dev/ttyp0 port1
/usr/sbin/kissattach /dev/ttyp1 port2
But none of the modem do work
Who has a TNC3S running ?
peter
PC2A
Peter,
Are you getting any error messages?
No! just the kisssattach message:
AX.25 port port1 bound to device ax0
AX.25 port port2 bound to device ax1
Are the port names in axports the same as used in kissattach and do
the port speeds match the TNC settings?
AX port:
port1 pi4cc-10 1200 256 7 tnc3 1
port2 pi4cc-11 9600 256 7 tnc3 2
Is mkiss available? I've read of it not being available by default.
Yes!
Is kissattach residing in /usr/sbin, or is it in /usr/local/sbin?
In /usr/sbin
Is the TNC in KISS mode?
Yes
I believe the use of an IP number is mandatory in kissattach. Even
non-routable numbers will do. I use 10.0.0.1 and 10.0.0.2 for my
loopback ports.
This is use to startup:
/usr/sbin/mkiss -s 38400 /dev/ttyS0 /dev/ptyp0 /dev/ptyp1
/usr/sbin/kissattach /dev/ttyp0 port1 10.0.0.101
/usr/sbin/kissattach /dev/ttyp1 port2 10.0.0.102
The ifconfig output:
ifconfig
ax0 Link encap:AMPR AX.25 HWaddr PI4CC-10
inet addr:10.0.0.101 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MTU:256 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
ax1 Link encap:AMPR AX.25 HWaddr PI4CC-11
inet addr:10.0.0.102 Bcast:10.255.255.255 Mask:255.0.0.0
UP BROADCAST RUNNING MTU:256 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:10
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)
Ray vk2tv
.
Peter
Reply to:
- References:
- TNC3S
- From: Peter <pc2a@pi4cc.nl>
- Re: TNC3S
- From: Ray Wells <vk2tv@exemail.com.au>