Re: Sun Ultra 2 sunhme sunqe IPTables Prob Perhaps
Chris Brandstetter wrote:
> Dear All,
> I am trying to setup a Sun Ultra 2 with the onboard sunhme, and 2
> sunqe cards as a firewall. THe problem I am having is that if I add
> sunqe to the modules file in /etc so that it loads on boot I get a
> list of about 20 iptables rules all for the sunhme port, and after
> that the system says the sunhme port is not connected to the ethernet
> cable. However if I just insmod the module after bootup everything
> works fine. I was wondering if anyone had any ideas what could be
> causeing this? Also, I was wondering where in the startup scripts it
> is setting up iptables, so I could try that and see if that is the
> problem.
This sounds like a problem with the netwok card numbering, i guess that
putting sunqe in /etc/mod..., then your sunqe are probed before your
sunhme card, and so you don't get the interface/card association as
expected.
I don't have THE solution, but...
Look at wich interface is associated at which card, and then modify your
iptables script according to.
Perhaps another solution is to not put sunqe in /etc/modules.conf, and
then load and configure these 2 network cards in /etc/rc.d/local or
something similar.
Christian
> --
> Chris Brandstetter
>
> -----Begin Geek Code----
> GCS d+ s++:++ a- C++++ U+++ L+++ P+++ E--- W+++ o K- w-- O M V PS
> PE Y+ PGP++ t++ 5+++ X++ R+ tv b++ DI+ D+ G e+ h++ r-- z?
> ------End Geek Code-------
> To Decode:http://www.ebb.org/ungeek/
>
Reply to: