Re: Add a videocard to Discover
|| On Tue, 22 Feb 2005 15:15:39 +0100
|| Paul van der Vlis <paul@vandervlis.nl> wrote:
pvdv> Hello,
pvdv> During install my videocard is not detected by Debconf. It is a cheap
pvdv> Nvidia compatible videocard what uses the "nv" driver.
pvdv> How can I tell the Discover-developpers about this videocard?
pvdv> With regards,
pvdv> Paul van der Vlis.
pvdv> BTW: This is from "lspci -vv"
pvdv> ---------
pvdv> 0000:01:00.0 VGA compatible controller: nVidia Corporation NV18
pvdv> [GeForce4 MX 4000 AGP 8x] (rev c1) (prog-if 00 [VGA])
pvdv> Control: I/O+ Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop-
pvdv> ParErr- Stepping- SERR- FastB2B-
pvdv> Status: Cap+ 66MHz+ UDF- FastB2B+ ParErr- DEVSEL=medium
>> TAbort- <TAbort- <MAbort- >SERR- <PERR-
pvdv> Latency: 64 (1250ns min, 250ns max)
pvdv> Interrupt: pin A routed to IRQ 193
pvdv> Region 0: Memory at ee000000 (32-bit, non-prefetchable) [size=16M]
pvdv> Region 1: Memory at f0000000 (32-bit, prefetchable) [size=128M]
pvdv> Expansion ROM at effe0000 [disabled] [size=128K]
pvdv> Capabilities: [60] Power Management version 2
pvdv> Flags: PMEClk- DSI- D1- D2- AuxCurrent=0mA
pvdv> PME(D0-,D1-,D2-,D3hot-,D3cold-)
pvdv> Status: D0 PME-Enable- DSel=0 DScale=0 PME-
pvdv> Capabilities: [44] AGP version 3.0
pvdv> Status: RQ=32 Iso- ArqSz=0 Cal=3 SBA+ ITACoh- GART64-
pvdv> HTrans- 64bit- FW+ AGP3+ Rate=x4,x8
pvdv> Command: RQ=1 ArqSz=0 Cal=0 SBA- AGP- GART64- 64bit-
pvdv> FW- Rate=<none>
pvdv> -----------
You need to pass the:
lspci -n
lspci
outputs. Better is report a bug in BTS for it.
--
O T A V I O S A L V A D O R
---------------------------------------------
E-mail: otavio@debian.org UIN: 5906116
GNU/Linux User: 239058 GPG ID: 49A5F855
Home Page: http://www.freedom.ind.br/otavio
---------------------------------------------
"Microsoft gives you Windows ... Linux gives
you the whole house."
Reply to: