In chapter 6.3.1.1. "Check available memory / low memory mode":
"If the installer runs in low memory mode, it is recommended to create a
relatively large swap partition (64–128MB)."
I could change that into something like 1-2 GB.
One might think, this is still "relatively small" these days, but it's
always enough for the installer, so I think that would be ok.
Ah, I realize that the above is completely bullshit:
the swap partition is not only for the installer, but later for installed
system as well (shame on me).
So should I change to "2-4 GB at least" ?