Bug#609466: installation-reports pseudo package
Hi,
Dom, 2011-01-09 às 18:21 +0100, Tomten Larsson escreveu:
> Package: installation-reports
>
> Boot method: <How did you boot the installer? CD
> Image version: <Full URL to image you downloaded is best> http://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-CD-1.iso
> Date: <Date and time of the install> 2011-01-09
>
> Machine: <Description of machine (eg, IBM Thinkpad R32)> Sun Sparc Ultra 10
> Processor: Ultra SPARC IIi 333 MHZ
> Memory: 1GB
> Partitions: <df -Tl will do; the raw partition table is preferred> ? didn't go that far
>
> Output of lspci -knn (or lspci -nn): didn't go that far
>
> Base System Installation Checklist: E
> [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
>
> Initial boot: [ ]
> Detect network card: [ ]
> Configure network: [ ]
> Detect CD: [ ]
> Load installer modules: [ ]
> Detect hard drives: [ ]
> Partition hard drives: [ ]
> Install base system: [ ]
> Clock/timezone setup: [ ]
>
>
> User/password setup: [ ]
> Install tasks: [ ]
> Install boot loader: [ ]
> Overall install: [ ]
>
> Comments/Problems:
>
> <Description of the install, in prose, and any thoughts, comments
> and ideas you had during the initial install.>
> start to boot and prints lots of messages on screen, but then stops
> the last messages are
> [0.000000] Booting Linux...
> [0.000000] Built 1 zonelists in Zone order, mobility grouping on. Total pages: 130071
> [0.000000] Kernel command line:
> [0.000000] PID hash table entries: 4096 (order: 12, 32768 bytes)
> [0.000000] clocksource: mult[300c5] shift[16]
> [0.000000] clockevent: mult[553f7ced] shift[32]
> [42.966816] Console: colour dummy device 80x25
> [43.020133] console handover: boot [earlyprom0] -> real [tty0]
> after this nothing seems to happen
>
> I have previously been running Sarge and FreeBSD 8.1 so the hardware should be fine.
> rescue mode has the same problem, expert mode has the same problem
>
> The following image has a similar problem, the error message is a bit different, but stops when doing something with the console
> http://cdimage.debian.org/debian-cd/5.0.7/sparc/iso-cd/debian-507-sparc-businesscard.iso
> last line is:
> [0.000000] console [tty0] enabled, bootconsole disabled
The latest debian installer release it's Squeeze Beta 2 (and RC1 is
about to be released [2]), can you try and report against this version?
1 - http://www.debian.org/devel/debian-installer/index.en.html
2 - http://cdimage.debian.org/cdimage/.squeeze_di_rc1/
--
Melhores cumprimentos/Best regards,
Miguel Figueiredo
http://www.DebianPT.org
Reply to: