Bug#418535: marked as done (Grub on wrong HDD after Etch installation)
Your message dated Wed, 12 Jan 2011 00:01:17 +0000
with message-id <1294790477.3497.134.camel@eeepc.Belkin>
and subject line
has caused the Debian Bug report #226758,
regarding Grub on wrong HDD after Etch installation
to be marked as done.
This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.
(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)
--
226758: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=226758
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message ---
Package: grub-installer
Version: 1.22
Hello, my computer has 2 hdd's, one serial ATA behind a Silicon Image
3112 chipset and one IDE as a secondary slave. I chose to install Etch
(stable) on a partition in the serial ata drive (sda), which went on
without problems. My motherboard, ABIT NF7-S rev 1.1 has an option in
BIOS to boot from serial ATA, so naturally I assumed grub would be
installed on the boot sector of sda. This wasn't the case, as grub was
installed on the PATA (IDE) drive hdb. I was able to overcome this by
simply choosing to boot from the IDE drive in BIOS, but I think this
behavior warrants a fix.
--- End Message ---
--- Begin Message ---
Hi,
Thanks for your report.
Closing as it's an installation report from debian installer version
which isn't supported anymore.
Feel free to test and report any issues against the current debian
installer release (Squeeze RC1) which supports more hardware and also
it's improved.
Thanks!
http://cdimage.debian.org/cdimage/squeeze_di_rc1/
--
Melhores cumprimentos/Best regards,
Miguel Figueiredo
http://www.DebianPT.org
--- End Message ---
Reply to: