[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#243892: marked as done ([i386] [beta3] [netinst] pcmcia NIC didn't come up at first or on reboot)

Your message dated Wed, 08 Sep 2010 03:58:35 +0000
with message-id <E1OtBnv-0005td-1h@ravel.debian.org>
and subject line Closing old installation report #243892
has caused the Debian Bug report #243892,
regarding [i386] [beta3] [netinst] pcmcia NIC didn't come up at first or on reboot
to be marked as done.

This means that you claim that the problem has been dealt with.
If this is not the case it is now your responsibility to reopen the
Bug report if necessary, and/or fix the problem forthwith.

(NB: If you are a system administrator and have no idea what this
message is talking about, this may indicate a serious mail system
misconfiguration somewhere. Please contact owner@bugs.debian.org
immediately.)


-- 
243892: http://bugs.debian.org/cgi-bin/bugreport.cgi?bug=243892
Debian Bug Tracking System
Contact owner@bugs.debian.org with problems
--- Begin Message --- 
Package: installation-reports

Debian-installer-version:
http://gluck.debian.org/cdimage/testing/sarge_d-i/i386/beta3/sarge-i386-netinst.iso
uname -a: Linux maulwurf 2.4.25-1-386 #1 Tue Feb 24 08:11:13 EST 2004 i686
GNU/Linux
Date: 2004-04-14
Method: netinst, boot from cdrom, http://ftp.de.debian.org

Machine: IBM Thinkpad 600
Processor: PII-266
Memory: 288 MB
Root Device: IDE
Root Size/partition table: 
maulwurf:~# cat /etc/fstab
# /etc/fstab: static file system information.
#
# <file system> <mount point>   <type>  <options>       <dump>  <pass>
proc            /proc           proc    defaults        0       0
/dev/hda6       /transfer       vfat    defaults        0       2
/dev/hda9       none            swap    sw              0       0
/dev/hda8       /               ext3    defaults,errors=remount-ro 0       1
/dev/hda7       /home           ext3    defaults        0       2
/dev/hda10      /work           ext3    defaults        0       2

Output of lspci:
maulwurf:~# lspci
pcilib: Cannot open /sys/bus/pci/devices
0000:00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host
bridge (AGP disabled) (rev 02)
0000:00:02.0 CardBus bridge: Texas Instruments PCI1250 (rev 02)
0000:00:02.1 CardBus bridge: Texas Instruments PCI1250 (rev 02)
0000:00:03.0 VGA compatible controller: Neomagic Corporation NM2160
[MagicGraph 128XD] (rev 01)
0000:00:07.0 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 01)
0000:00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev 01)
0000:00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 01)

Base System Installation Checklist:

Initial boot worked:    [O]
Configure network HW:   [E]
Config network:         [E]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [Ó]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Comments/Problems:
I use a Xircom Realport Ethernet/Modem-Card in a DHCP environment; my
network card allways gets the same IP address according to it's MAC address.
The sarge netinst-image beta 3 booted without any option given, but there is
no network. 
My "workaround" was to switch to another console, entered "ifconfig", found
that there was no interface than "lo", did "/etc/init.d/pcmcia restart"
followed by "/etc/init.d/networking restart" and finally i got my ip address
via dhcp. Then i successfully did the installation from ftp.de.debian.org,
but after a reboot the network has gone again.

Despite that, the sarge-netinst-image is ok, but the german translators
should spell-check again...



-- 
NEU : GMX Internet.FreeDSL
Ab sofort DSL-Tarif ohne Grundgebühr: http://www.gmx.net/info

--- End Message ---
--- Begin Message --- 
We are closing this installation report for one of the following
reasons:
- it was reported with a pre-lenny version of Debian
  Installer.
- indications in the installation report give the feeling that
  the reported problem waslying in another software, unrelated to
  D-I, which we can't easily identify.
- indications in the installation report suggest that it may have been
  fixed in a more recent version of a D-I component
- it was successful and we forgot closing it..:-)
- it has no information we consider useful


The D-I team is currently in the process of cleaning out the old spool
of installation reports that haven't bene processed yet. 

In case you think that the problem you reported has chances to be
still present, please reiterate your installation test with
a more recent image of D-I, if you're in position of doing this.

You'll find daily builds at
http://www.debian.org/devel/debian-installer. We recommend you choose
the netboot image, in the "daily builds section", then choose to
install "squeeze" when prompted.

If some problems are found, please report them with a new bug sent
against installation-reports.

Many thanks for your understanding and your help improving Debian,
past and present.

--- End Message ---
Reply to: