Bug#330750: installation stops when scanning disks
On Thu, Sep 29, 2005 at 07:03:02PM +0200, Stefan.Zauner@gmx.de wrote:
> Package: installation-reports
>
> Debian-installer-version: 24.9.2005 from different mirrors (downloaded by
> "Free Download manager)
Is this the testing/unstable installer from that date?
> md5 sum was correct
> uname -a: no shell prompt, didn't even get this far
Available by switching to console 2 at almost any point during install.
> Date: 29.9.2005
> Method: Booted from DVD-ROM (Secondary Master)
> no boot parameters
>
> Machine: selfconstructed
What motherboard/chipset?
> Processor: Intel P4 3000 Mhz HT
> Memory: 1GB in dual mode (Kingtson HyperX)
> Root Device: Seagate SATA 80GB
> Root Size/partition table: n/a
> Disk configuration: 1. device: Seagate SATA 80GB
> (2 Windows partitions)
> 2. device: Seagate IDE 120GB
> (first 15GB free, 2 further Windows partitions)
> Output of lspci and lspci -n: n/a
>
> Base System Installation Checklist:
> [O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
>
> Initial boot worked: [O]
> Configure network HW: [O]
> Config network: [O]
> Detect CD: [O]
> Load installer modules: [O]
> Detect hard drives: [E]
> Partition hard drives: [ ]
> Create file systems: [ ]
> Mount partitions: [ ]
> Install base system: [ ]
> Install boot loader: [ ]
> Reboot: [ ]
>
> Comments/Problems:
>
> Installer stops at "Lade Programm f?r die Partitionierung"
> status bar at 38%
> "Durchsuche Festplatten..."
Any chance the sata drive is on a sil3112 controller and having the
known seagate sata+sil3112 problem?
Len Sorensen
Reply to: