Bug#307622: installation-reports
Hi,
I forgot to send it to to bugs.debian.org too. So I am sending it again.
> > Comments/Problems:
> >
> > Neither of the boot loaders (grub/lilo) could be installed on the RAID
> > Devices.
>
> To where did you tried to install boot loaders (MBR, some device)? What
> error messages were displayed by them. AFAIK grub should support this
> configuration.
I first tried to install the boot loaders with the debian-installer. But that
failed. Grub had an error (if i remember correctly) that it couldn't be
installed to /target/ and lilo said it couldn't be installed. Choosing a
manually lilo target in lilo had as default /dev/md/0.
Manually (as I described) it worked perfect.
Maybe it has to do with the Onboard Raid Controller, i am not sure if lspci
shows it. It is a Cont. Raid Promise PDC20319 4-Channel SATA RAID 0,1. But I
disabled it in the Bios (The raid functionality), so the two SATA harddisks
are IDE third and fourth master. I think the RAID Controller is for sure not
a "real" hardware raid controller. But as the software raid seems to do the
job very well I didn't try any further.
If you have any further questions feel free to contacting me.
Regards,
Claus Grill
Reply to: