Bug#272636: installation-reports: Netra T105: nearly perfect
Package: installation-reports
Debian-installer-version: 20040802 netboot
Date: 2004-09-19
Severity: normal
Method: rarp+tftp+http from http.us.debian.org
Machine: Sun Netra T105
Processor: TI UltraSparc IIi (Sabre)
Memory: 311296k
Root Device: Seagate ST39102LC, symbios SCSI
Partition Table:
Disk /dev/sda (Sun disk label): 12 heads, 214 sectors, 6922 cylinders
Units = cylinders of 2568 * 512 bytes
Device Flag Start End Blocks Id System
/dev/sda1 0 1 1284 83 Linux native
/dev/sda2 u 1 409 523872 82 Linux swap
/dev/sda3 0 6922 8887848 5 Whole disk
/dev/sda4 409 6922 8362692 83 Linux native
/dev/sda4 on / type ext3 (rw,errors=remount-ro)
proc on /proc type proc (rw)
devpts on /dev/pts type devpts (rw,gid=5,mode=620)
tmpfs on /dev/shm type tmpfs (rw)
usbfs on /proc/bus/usb type usbfs (rw)
flurp:~# lspci
0000:00:00.0 Host bridge: Sun Microsystems Computer Corp. Ultra IIi
0000:00:01.0 PCI bridge: Sun Microsystems Computer Corp. Simba Advanced
PCI Bridge (rev 13)
0000:00:01.1 PCI bridge: Sun Microsystems Computer Corp. Simba Advanced
PCI Bridge (rev 13)
0000:01:01.0 Bridge: Sun Microsystems Computer Corp. EBUS (rev 01)
0000:01:01.1 Ethernet controller: Sun Microsystems Computer Corp. Happy
Meal (rev 01)
0000:01:02.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875
(rev 03)
0000:01:03.1 Ethernet controller: Sun Microsystems Computer Corp. Happy
Meal (rev 01)
0000:02:01.0 PCI bridge: Digital Equipment Corporation DECchip 21150
(rev 04)
0000:03:0e.0 IDE interface: Silicon Image, Inc. (formerly CMD Technology
Inc) PCI0646 (rev 03)
flurp:~# lspci -n
0000:00:00.0 0600: 108e:a000
0000:00:01.0 0604: 108e:5000 (rev 13)
0000:00:01.1 0604: 108e:5000 (rev 13)
0000:01:01.0 0680: 108e:1000 (rev 01)
0000:01:01.1 0200: 108e:1001 (rev 01)
0000:01:02.0 0100: 1000:000f (rev 03)
0000:01:03.1 0200: 108e:1001 (rev 01)
0000:02:01.0 0604: 1011:0022 (rev 04)
0000:03:0e.0 0101: 1095:0646 (rev 03)
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [ ]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
Comments:
Flawless install, except for one issue -- did the install over a serial
console w/ minicom, as usual on Netra hardware. It's all in mono with
some boldface highlighting on active options, but after the reboot, the
highlighting didn't appear in debconf dialogs, making it hard to
navigate. On a subsequent boot I installed and configured ssh over the
same console and the highlighting was visible again.
-- System Information:
Debian Release: 3.1
APT prefers testing
APT policy: (500, 'testing')
Architecture: sparc (sparc64)
Kernel: Linux 2.4.26-sparc64
Locale: LANG=C, LC_CTYPE=C
Reply to: