Bug#266605: Succesfull sarge install with rc1 d-i
Package: installation-reports
Debian-installer-version: rc1
uname -a: Linux etdb 2.6.7-1-686 #1 Thu Jul 8 05:36:53 EDT 2004 i686
GNU/Linux
Date: Wed Aug 18 14:53:57 EEST 2004
Method: floppy buut, usb memory with netinstall iso
Machine: Dell Optiplex GX1
Processor: Pentium 2 400MHz
Memory: 128MB
Root Device: IDE one disk
Output of lspci:
0000:00:00.0 Host bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX Host
bridge (rev 03)
0000:00:01.0 PCI bridge: Intel Corp. 440BX/ZX/DX - 82443BX/ZX/DX AGP
bridge (rev 03)
0000:00:07.0 ISA bridge: Intel Corp. 82371AB/EB/MB PIIX4 ISA (rev 02)
0000:00:07.1 IDE interface: Intel Corp. 82371AB/EB/MB PIIX4 IDE (rev 01)
0000:00:07.2 USB Controller: Intel Corp. 82371AB/EB/MB PIIX4 USB (rev
01)
0000:00:07.3 Bridge: Intel Corp. 82371AB/EB/MB PIIX4 ACPI (rev 02)
0000:00:0f.0 PCI bridge: Digital Equipment Corporation DECchip 21152
(rev 03)
0000:00:11.0 Ethernet controller: 3Com Corporation 3c905B 100BaseTX
[Cyclone] (rev 24)
0000:01:00.0 VGA compatible controller: ATI Technologies Inc 3D Rage Pro
AGP 1X/2X (rev 5c)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [ ]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [E]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Is there any way to run bad blocks without using expert mode?
I already upgraded my kernel so uname output isn't from same
kernel which I used when installing.
Btw why there in no 2.6 kernel boot floppies?
--
Janne Kujanpää
Reply to: