Re: How does installer configure modules used after reboot?
[Tod Hagan]
> I've got a case where debian-installer RC1 fails on reboot. I'm
> writing up my installation report, but first I have a question.
Remember both lspci and lspci -n. :)
> I'm not sure that the necessary modules are loaded to see the RAIDed
> drives holding the install. Would these modules have to appear in the
> modprobe entries in the loadmodules file in
> /boot/initrd.img-2.4.26-1-386?
Yes, I believe so.
> Is /boot/initrd.img-2.4.26-1-386 created dynamically during install,
> or is it stored in a .deb within sarge-i386-netinst.iso?
It is generated when the kernel package is installed, and I believe it
is done by mkinitrd. Check the postinst of a kernel package.
Reply to: