Bug#264433: (no subject)
Package: installation-reports
Debian-installer-version: RC1 for hppa from Debian server
uname -a: N/A
Date: 8th Aug 2004, 22:50 CEST
Method: Booted from CD-ROM (boot p9 after firmware boot device search)
Machine: HP 9000 D270 HPPA server, HP Disk array
Processor:2 x PA-RISC (160MHz ??)
Memory: 768MB
Root Device: SCSI CDROM - booted from firmware as BOOT P9
Root Size/partition table: N/A
Output of lspci:N/A
Base System Installation Checklist:
Initial boot worked: [E]
Configure network HW: [ ]
Config network: [ ]
Detect CD: [ ]
Load installer modules: [ ]
Detect hard drives: [ ]
Partition hard drives: [ ]
Create file systems: [ ]
Mount partitions: [ ]
Install base system: [ ]
Install boot loader: [ ]
Reboot: [ ]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
I booted with BOOT P9 and asked to interact with the IPL. Having
checked the defaults (this machine has no graphics card, so the console
needs to default to serial, which it did), I accepted the defaults and
the kernel booted. I stopped at "Setting up filesystem, please wait..."
and went no further. I therefore could not install the system.
Many thanks and kind regards;
Philip
Reply to: