Bug#264348: Test
Package: installation-reports
Version: 08.08.04
Debian-installer-version:
http://cdimage.debian.org/pub/cdimage-testing/daily/i386/20040805/
uname -a: Linux debian 2.4.26-1-386 #2 Sat May 1 16:31:24 EST 2004 i686
Date: 8th August 04 20:00
Method: Booted from network install iso
Machine: Selfconfiguered P4
Processor: P4 2,8 GHz HT
Memory: 1 GB
Root Device: /dev/hda LG DVDRAM GSA-4040B
/dev/sda ST316002 3A SATA Drive
/dev/sdb ST316002 3A SATA Drive
/dev/hdb LD CDRW GSA-40
Mobo: Asus P4C800-E Deluxe with 2 SATA Controller
Intel ICH5 and
Promise Onboard Raid Controller
Network: DLink 650 Rev. B
Netgear MA111 802.11b Wireless USB Adapter
Root Size/partition table:
table, with notes on which partitions are mounted where.>
Output of lspci:
Base System Installation Checklist:
Initial boot worked: [X]
Configure network HW: [E]
Config network: [E]
Detect CD: [X]
Load installer modules: [X]
Detect hard drives: [X]
Partition hard drives: [E]
Create file systems: [E]
Mount partitions: [E]
Install base system: [E]
Install boot loader: [E]
Reboot: [X]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
dmesg:
0 0 0 0 1 1 69
0a 000 00 1 0 0 0 0 0 0 00
0b 080 00 1 0 0 0 0 0 2 FF
0c 001 01 0 0 0 0 0 1 1 71
0d 001 01 0 0 0 0 0 1 1 79
0e 001 01 0 0 0 0 0 1 1 81
0f 001 01 0 0 0 0 0 1 1 89
10 001 01 1 1 0 1 0 1 1 91
11 001 01 1 1 0 1 0 1 1 91
12 001 01 1 1 0 1 0 1 1 99
13 001 01 1 1 0 1 0 1 1 91
14 001 01 1 1 0 1 0 1 1 A1
15 000 00 1 0 0 0 0 0 0 00
16 001 01 1 1 0 1 0 1 1 99
17 001 01 1 1 0 1 0 1 1 A1
IRQ to pin mappings:
IRQ0 -> 0:2
IRQ1 -> 0:1
IRQ3 -> 0:3
IRQ4 -> 0:4
IRQ5 -> 0:18-> 0:22
IRQ6 -> 0:6
IRQ7 -> 0:7
IRQ8 -> 0:8
IRQ9 -> 0:9
IRQ10 -> 0:16-> 0:17-> 0:19
IRQ11 -> 0:20-> 0:23
IRQ12 -> 0:12
IRQ13 -> 0:13
IRQ14 -> 0:14
IRQ15 -> 0:15
.................................... done.
Using local APIC timer interrupts.
calibrating APIC timer ...
..... CPU clock speed is 2798.7884 MHz.
..... host bus clock speed is 199.9132 MHz.
cpu: 0, clocks: 1999132, slice: 999566
CPU0<T0:1999120,T1:999552,D:2,S:999566,C:1999132>
ACPI: Subsystem revision 20040326
ACPI: Interpreter disabled.
PCI: PCI BIOS revision 2.10 entry at 0xf0031, last bus=2
PCI: Using configuration type 1
PCI: Probing PCI hardware
PCI: ACPI tables contain no PCI IRQ routing entries
PCI: Probing PCI hardware (bus 00)
PCI: Ignoring BAR0-3 of IDE controller 00:1f.1
Transparent bridge - Intel Corp. 82801BA/CA/DB/EB PCI Bridge
PCI: Using IRQ router PIIX/ICH [8086/24d0] at 00:1f.0
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Starting kswapd
VFS: Disk quotas vdquot_6.5.1
devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT
SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
COMX: driver version 0.85 (C) 1995-1999 ITConsult-Pro Co. <info@itc.hu>
RAMDISK driver initialized: 16 RAM disks of 10240K size 1024 blocksize
Initializing Cryptographic API
NET4: Linux TCP/IP 1.0 for NET4.0
IP: routing cache hash table of 8192 buckets, 64Kbytes
TCP: Hash tables configured (established 262144 bind 65536)
Linux IP multicast router 0.06 plus PIM-SM
RAMDISK: Compressed image found at block 0
Freeing initrd memory: 2848k freed
VFS: Mounted root (ext2 filesystem).
Mounted devfs on /dev
VFS: Mounted root (ext2 filesystem).
Trying to move old root to /initrd ... okay
Mounted devfs on /dev
Freeing unused kernel memory: 92k freed
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
vga16fb: initializing
vga16fb: mapped to 0xc00a0000
Console: switching to colour frame buffer device 80x30
fb0: VGA16 VGA frame buffer device
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb-uhci.c: $Revision: 1.275 $ time 16:13:08 May 1 2004
usb-uhci.c: High bandwidth mode enabled
PCI: Setting latency timer of device 00:1d.0 to 64
usb-uhci.c: USB UHCI at I/O 0xeec0, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 1
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Setting latency timer of device 00:1d.1 to 64
usb-uhci.c: USB UHCI at I/O 0xef00, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 2
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Setting latency timer of device 00:1d.2 to 64
usb-uhci.c: USB UHCI at I/O 0xef20, IRQ 5
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 3
hub.c: USB hub found
hub.c: 2 ports detected
PCI: Setting latency timer of device 00:1d.3 to 64
usb-uhci.c: USB UHCI at I/O 0xef40, IRQ 10
usb-uhci.c: Detected 2 ports
usb.c: new USB bus registered, assigned bus number 4
hub.c: USB hub found
hub.c: 2 ports detected
usb-uhci.c: v1.275:USB Universal Host Controller Interface driver
PCI: Setting latency timer of device 00:1d.7 to 64
ehci_hcd 00:1d.7: Intel Corp. 82801EB USB2
ehci_hcd 00:1d.7: irq 11, pci mem f883bc00
usb.c: new USB bus registered, assigned bus number 5
ehci_hcd 00:1d.7: enabled 64bit PCI DMA
PCI: cache line size of 128 is not supported by device 00:1d.7
ehci_hcd 00:1d.7: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4
hub.c: USB hub found
hub.c: 8 ports detected
usb.c: registered new driver usbkbd
usbkbd.c: :USB HID Boot Protocol keyboard driver
usb.c: registered new driver serial
usbserial.c: USB Serial support registered for Generic
usbserial.c: USB Serial Driver core v1.4
hub.c: connect-debounce failed, port 2 disabled
hub.c: new USB device 00:1d.7-3, assigned address 2
usb.c: USB device 2 (vend/prod 0x41e/0x3020) is not claimed by any active
driver.
hub.c: new USB device 00:1d.0-2, assigned address 2
usb.c: USB device 2 (vend/prod 0x846/0x4110) is not claimed by any active
driver.
hub.c: new USB device 00:1d.2-2, assigned address 2
usb.c: USB device 2 (vend/prod 0x47f/0xca1) is not claimed by any active
driver.
ohci1394: $Rev: 1045 $ Ben Collins <bcollins@debian.org>
ohci1394_0: OHCI-1394 1.0 (PCI): IRQ=[11] MMIO=[feaff800-feafffff] Max
Packet=[2048]
SCSI subsystem driver Revision: 1.00
libata version 1.02 loaded.
sata_promise version 0.92
ata1: SATA max UDMA/133 cmd 0xF889F200 ctl 0xF889F238 bmdma 0x0 irq 11
ata2: SATA max UDMA/133 cmd 0xF889F280 ctl 0xF889F2B8 bmdma 0x0 irq 11
ieee1394: Host added: ID:BUS[0-00:1023] GUID[00e01800003f37a2]
ata1: no device found (phy stat 00000000)
ata1: thread exiting
ata2: no device found (phy stat 00000000)
ata2: thread exiting
scsi0 : sata_promise
scsi1 : sata_promise
Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
USB Mass Storage support registered.
inserting floppy driver for 2.4.26-1-386
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
ide: late registration of driver.
ICH5: IDE controller at PCI slot 00:1f.1
PCI: Enabling device 00:1f.1 (0005 -> 0007)
ICH5: chipset revision 2
ICH5: not 100% native mode: will probe irqs later
ide0: BM-DMA at 0xfc00-0xfc07, BIOS settings: hda:DMA, hdb:pio
ide1: BM-DMA at 0xfc08-0xfc0f, BIOS settings: hdc:DMA, hdd:pio
hda: HL-DT-ST DVDRAM GSA-4040B, ATAPI CD/DVD-ROM drive
hdc: HL-DT-ST RW/DVD GCC-4520B, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: attached ide-cdrom driver.
hda: ATAPI 24X DVD-ROM DVD-R-RAM CD-R/RW drive, 2048kB Cache, UDMA(33)
Uniform CD-ROM driver Revision: 3.12
hdc: attached ide-cdrom driver.
hdc: ATAPI 52X DVD-ROM CD-R/RW drive, 2048kB Cache, UDMA(33)
sbp2: $Rev: 1074 $ Ben Collins <bcollins@debian.org>
scsi singledevice 0 0 0 0
Linux Kernel Card Services 3.1.22
options: [pci] [cardbus] [pm]
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
Intel ISA PCIC probe: not found.
Intel ISA PCIC probe: not found.
ISO 9660 Extensions: Microsoft Joliet Level 3
ISO 9660 Extensions: RRIP_1991A
scsi singledevice 0 0 0 0
Intel ISA PCIC probe: not found.
Intel ISA PCIC probe: not found.
ds: no socket drivers loaded!
scsi singledevice 0 0 0 0
Intel ISA PCIC probe: not found.
Intel ISA PCIC probe: not found.
Journalled Block Device driver loaded
SGI XFS with ACLs, no debug enabled
SGI XFS Quota Management subsystem
VFS: Can't find ext2 filesystem on dev fd(2,0).
cramfs: wrong magic
Unable to identify CD-ROM format.
Kind regards
Burkhard Dunkel
Reply to: