Bug#255545: hppa d-i install success!
Package: installation-reports
Debian-installer-version: jbailey's 21.06.2004 daily build
uname -a:
Linux caradhras 2.4.26-32-smp #1 SMP Thu Apr 29 03:20:53 UTC 2004 parisc GNU/Linux
Date: Mon Jun 21 13:33:07 EDT 2004
Method: Network booted from local TFTP server.
Machine: HP Visualize B180L+
Processor: PA7300LC 180MHz
Memory: 416784k
Root Device: /dev/sda
Root Size/partition table:
Device Boot Start End Blocks Id System
/dev/sda1 1 31 31728 f0 Linux/PA-RISC boot
/dev/sda2 32 275 249856 82 Linux swap
/dev/sda3 * 276 1740 1500160 83 Linux
/dev/sda4 1741 4091 2407424 83 Linux
sda3 is root, sda4 is /home
Output of lspci:
caradhras:~# lspci
0000:00:13.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 04)
0000:00:14.0 Ethernet controller: Digital Equipment Corporation DECchip 21142/43 (rev 41)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
System came up fine! Used tasksel to install a few tasks with
no issues. The only conceivable problem is that in my xterm running
minicom to the B180, tasksel does not highlight what you currently have
tabbed, which meant I had to play guessing games to figure out how to
hit "Finish." Will try using aptitude on tomorrow's build.
Will try tc2 with a cd-rom boot, when it's released.
Thanks!
--
Kyle McMartin
Reply to: