[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#249286: Sony PCG-FX505/WiFi install



* j@thing.net <j@thing.net> [2004-05-16 16:26]:
> netgear wlan card was detected and driver was loaded, i could not see or
> select the ESSID of the network it connected to, but was only asked for
> a WEP key.
> 
> since there is no dhcp on the net, dhcp failed; the installer did
> not offer me the manual config instead, but tried to access the debian
> mirror. back in the main menu, typing in the ip address the interface
> was not configured. switched to the console and configured it by hand.

joshk, any idea?

> the hard disk had two ntfs paritions, of wich i wanted to delete one
> and keep the other to copy the data later. this was not able with
> partman, since it only allows me to delete the howl disk, but not a
> single partition.

If you go to "manual partition the disk", you should see the different
partitions.  You can then go to a partition, press enter, and you'll
see a menu asking you what to do.  One of the points at the bottom is
"delete partition".  Can you try if that works?

> i could not find a way to install cfdisk as udeb or another

If you open a shell and run cfdisk, it should work, but there's
currently no menu for this.  Someone else requested this recently,
though.

> after rebooting the wlan interface moved from eth1 to eth2 since the
> firewire interface was found and used as eth1.

Are you sure firewire took up eth1 and not your Realtek Ethernet chip?
(or is that eth0, I guess?).  Why would firewire appear as an eth
device?  Is that some kind of firewire ethernet?

-- 
Martin Michlmayr
tbm@cyrius.com



Reply to: