Bug#247367: Almost successful installation
Package: installation-reports
Debian-installer-version: debain.org beta4
uname -a: 2.4.25-1-386
Date: May 04 2004 14:00 GMT +1
Method: 110MB CD image, ftp install from debian.essentkabel.nl, masquerated
Machine: MSI-K7T266 Pro v1.0,
Processor: AMD Athlon 750
Memory: 512 DDR
Root Device: IDE /dev/hda2
Root Size/partition table:
Device Boot Start End Blocks Id System
/dev/hda1 1 969 488344+ 83 Linux swap
/dev/hda2 970 20345 9765504 83 Linux /
/dev/hda3 20346 155060 67896360 83 Linux /home
Output of lspci:
pcilib: Cannot open /sys/bus/pci/devices
0000:00:00.0 Host bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo KT266/A/333]
0000:00:01.0 PCI bridge: VIA Technologies, Inc. VT8366/A/7 [Apollo KT266/A/333 AGP]
0000:00:05.0 Unknown mass storage controller: Promise Technology, Inc. 20269 (rev 02)
0000:00:06.0 Unknown mass storage controller: Promise Technology, Inc.: Unknown device 3375 (rev 02)
0000:00:07.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 78)
0000:00:11.0 ISA bridge: VIA Technologies, Inc. VT8233 PCI to ISA Bridge
0000:00:11.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT823x/A/C/VT8235 PIPC Bus Master IDE (rev 06)
0000:00:11.2 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0 controller] (rev 18)
0000:00:11.3 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0 controller] (rev 18)
0000:00:11.4 USB Controller: VIA Technologies, Inc. VT6202 [USB 2.0 controller] (rev 18)
0000:01:00.0 VGA compatible controller: Matrox Graphics, Inc. MGA G100 [Productiva] AGP (rev 02)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [O]
Load installer modules: [O]
Detect hard drives: [O]
Partition hard drives: [O]
Create file systems: [O]
Mount partitions: [O]
Install base system: [O]
Install boot loader: [O]
Reboot: [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Most went fine, but:
In fdisk hda1 has type 83 (should be 82 swap), the swap was however used correctly, changing the type manualy was no problem.
When installing Squid, the hostname was unknown to the startup script, it could be a problem with the squid package, but anyway:
Starting proxy server: Creating squid spool directory structure
FATAL: Could not determine fully qualified hostname. Please set 'visible_hostname'
lspci:
pcilib: Cannot open /sys/bus/pci/devices
After installing the 2.6.3-1-k7 kernel the error was gone.
Met vriendelijke groet,
Herman van Rink
InitFour Webhosting
Website: http://www.initfour.nl
Email: info@initfour.nl
Reply to: