[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Bug#238640: sucess



Package: installation-reports

Debian-installer-version: March 16 2004 debian installer web site
uname -a: Linux debian 2.4.25-1-k7 #1 Tue Feb 24 14:24:28 EST 2004 i686 GNU/Linux
Date: March 16 2004
Method: 30 meg CD and ethernet card connected to cable modem
Machine: homebuilt AMD AZ11E motherboard
Processor: AMD
Memory: 512 meg
Root Device: IDE /dev/hda1
Root Size/partition table: Disk /dev/hda: 20.4 GB, 20491075584 bytes
255 heads, 63 sectors/track, 2491 cylinders
Units = cylinders of 16065 * 512 = 8225280 bytes

  Device Boot      Start         End      Blocks   Id  System
/dev/hda1   *           1        2429    19510911   83  Linux
/dev/hda2            2430        2491      498015    f  W95 Ext'd (LBA)
/dev/hda5            2430        2491      497983+  82  Linux swap

Output of lspci:

00:00.0 Host bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133] (rev 03)
00:01.0 PCI bridge: VIA Technologies, Inc. VT8363/8365 [KT133/KM133 AGP]
00:07.0 ISA bridge: VIA Technologies, Inc. VT82C686 [Apollo Super South] (rev 40)
00:07.1 IDE interface: VIA Technologies, Inc. VT82C586A/B/VT82C686/A/B/VT8233/A/C/VT8235 PIPC Bus Master IDE (rev 06)
00:07.2 USB Controller: VIA Technologies, Inc. USB (rev 16)
00:07.3 USB Controller: VIA Technologies, Inc. USB (rev 16)
00:07.4 Bridge: VIA Technologies, Inc. VT82C686 [Apollo Super ACPI] (rev 40)
00:07.5 Multimedia audio controller: VIA Technologies, Inc. VT82C686 AC97 Audio Controller (rev 50)
00:09.0 FireWire (IEEE 1394): VIA Technologies, Inc. IEEE 1394 Host Controller (rev 46)
00:0c.0 Ethernet controller: Lite-On Communications Inc LNE100TX (rev 20)
01:00.0 VGA compatible controller: nVidia Corporation NV6 [Vanta/Vanta LT] (rev 15)

Base System Installation Checklist:

Initial boot worked:    [O]
Configure network HW:   [O]
Config network:         [O]
Detect CD:              [O]
Load installer modules: [O]
Detect hard drives:     [O]
Partition hard drives:  [O]
Create file systems:    [O]
Mount partitions:       [O]
Install base system:    [O]
Install boot loader:    [O]
Reboot:                 [O]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it

Comments/Problems: It defaulted to vesa instead of nv. VESA didn't work.
I kept rerunning the dpkg command and didn't realize it wasn't writing to the XF86Config file. It would be
nice if you could rerun part of the installation without downloading everything all
or typing commands at a shell prompt. Did I miss the printer and sound set up?
I'm still trying to figure it out.  I think I remember skipping the printer setup.
I wanted cups support and I wasn't sure the installer was going to do that.
I don't remember it saying anything about what kind of filter it would install.





Reply to: