Bug#238044:
Package: installation-reports
INSTALL REPORT
Debian-installer-version: sarge-i386-netinst.iso 03-Jan-2004
http://gluck.debian.org/cdimage/testing/sarge_d-i/i386/beta2/
uname -a: Linux anime-station 2.4.22-1-386 #9 Sat Oct 4 14:30:39 EST 2003 i686
GNU/Linux
Date: Mon Mar 15 02:14:40 EET 2004
Method: Boot off cd, expert mode, net install from ftp.debian.org, not proxied
Machine: IBM clone
Processor: Intel P4 1.7
Memory: 256 MB DDR
Root Device: IDE Western Digital 40GB on I845 chipset
Root Size/partition table:
/dev/hda1 1 5 40131 83 Linux #/boot
/dev/hda2 6 49 353430 82 Linux swap
/dev/hda3 50 550 4024282+ 83 Linux #/
/dev/hda4 551 4865 34660237+ 5 Extended
/dev/hda5 551 4865 34660206 83 Linux
Output of lspci:
00:00.0 Host bridge: Intel Corp. 82845 845 (Brookdale) Chipset Host Bridge
(rev 03)
00:01.0 PCI bridge: Intel Corp. 82845 845 (Brookdale) Chipset AGP Bridge (rev 03)
00:1e.0 PCI bridge: Intel Corp. 82801BA/CA/DB/EB PCI Bridge (rev 12)
00:1f.0 ISA bridge: Intel Corp. 82801BA ISA Bridge (LPC) (rev 12)
00:1f.1 IDE interface: Intel Corp. 82801BA IDE U100 (rev 12)
00:1f.2 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #1) (rev 12)
00:1f.4 USB Controller: Intel Corp. 82801BA/BAM USB (Hub #2) (rev 12)
00:1f.5 Multimedia audio controller: Intel Corp. 82801BA/BAM AC'97 Audio (rev 12)
01:00.0 VGA compatible controller: nVidia Corporation NV11 [GeForce2 MX/MX
400] (rev b2)
02:0c.0 Ethernet controller: VIA Technologies, Inc. VT6105 [Rhine-III] (rev 8b)
Base System Installation Checklist:
Initial boot worked: [0]
Configure network HW: [0]
Config network: [0]
Detect CD: [0]
Load installer modules: [0]
Detect hard drives: [0]
Partition hard drives: [ ]
Create file systems: [0]
Mount partitions: [0]
Install base system: [0]
Install boot loader: [E]
Reboot: [0]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
Used expert mode.
Configured static network.
Hard disk was already partitioned from previous Gentoo installation, so i
just created/mounted filesystems (ext2 for boot, reiserfs and swap).
Installed Grub, but it failed to boot after reboot, because it had (hd0,2) as
the root partition instead of (hd0,0) which is where i mounted /boot. So I had
to boot via grub command-line.
Base-config run fine.
I got two stalls while downloading packages which resulted in the packages
being skipped.
Installation proceeded fine after retry in both cases.
Reply to: