Package: installation-reports
Debian-installer-version: 20040102 http.us.debian.org
uname -a:
Date: 2004/02/09 10:30 CET
Method: Netinst from floppy. Behind a linux firewall with NAT and http proxy.
Installation source was ftp.kfki.hu mirror
Machine: HP DL 360 G2
Processor: GenuineIntel P III 1400 MHz.
Memory: 512 MB
Root Device: HP CISS controller
Root Size/partition table:
/dev/cciss/c0d0p3 4.7G /
/dev/cciss/c0d0p1 191M /boot
/dev/cciss/c0d0p5 1.0G /tmp
/dev/cciss/c0d0p6 9.3G /usr
/dev/cciss/c0d0p7 18G /var
Output of lspci:
00:00.0 Host bridge: ServerWorks CNB20HE Host Bridge (rev 23)
00:00.1 Host bridge: ServerWorks CNB20HE Host Bridge (rev 01)
00:00.2 Host bridge: ServerWorks: Unknown device 0006 (rev 01)
00:00.3 Host bridge: ServerWorks: Unknown device 0006 (rev 01)
00:03.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
00:05.0 System peripheral: Compaq Computer Corporation: Unknown device b203 (rev 01)
00:05.2 System peripheral: Compaq Computer Corporation: Unknown device b204 (rev 01)
00:0f.0 ISA bridge: ServerWorks CSB5 South Bridge (rev 92)
00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 92)
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 OHCI USB Controller (rev 05)
00:0f.3 Host bridge: ServerWorks: Unknown device 0230
01:04.0 RAID bus controller: Compaq Computer Corporation Smart Array 5i/532 (rev 01)
01:05.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5701 Gigabit Ethernet (rev 15)
01:06.0 Ethernet controller: BROADCOM Corporation NetXtreme BCM5701 Gigabit Ethernet (rev 15)
Base System Installation Checklist:
Initial boot worked: [O]
Configure network HW: [O]
Config network: [O]
Detect CD: [ ]
Load installer modules: [O]
Detect hard drives: [E]
Partition hard drives: [E]
Create file systems: [E]
Mount partitions: [E]
Install base system: [O]
Install boot loader: [E]
Reboot: [E]
[O] = OK, [E] = Error (please elaborate below), [ ] = didn't try it
Comments/Problems:
I can do the partitioning but after the created partitions are not mountable. If I try to select on the gui it gets back to the main screen. After I made the filesystems and the mounts under /target manually I was able to install the base system. The boot loader was unable to install itself. I tried lilo and grub with the same result. I cannot make it usable.