Re: Gigabyte MP30AR0 - UEFI MMC
W dniu 22.10.2023 o 17:56, Michael Howard pisze:
My situation with the MP30AR0 is that when booting from u-boot I only
get one 10Gbe nic but the sdcard (mmc) is available. If I chainload the
Tianocore uefi from u-boot (I've never flashed uefi directly on this
board) I get both 10Gbe nics but the sdcard/mmc is no longer available.
MP30AR0 is APM X-Gene 1 board (like APM Mustang was), right?
I'm trying to make it so all four sata ports can be used for data and
boot the os from sdcard. I can boot from nfs/usb but would like to get
the sdcard working.
On APM Mustang SD slot was basically backup storage for firmware. When
UEFI was used (I never used U-Boot on it) it could have it in on-board
flash or on SD card (depends on jumper setup). Never used SD card under
Linux. USB ports should work just fine (unless you run kernel older than
3.19).
I have had no success with_any_ pcie cards so can't currently go down
that route.
Neither under UEFI not U-Boot? Weird.
I'm currently using the latest mainline kernel but I've tried many along
the way.
Mainline should work on those boards. But it may be hard to find someone
who still use X-Gene based systems. They are 10 years old now...
Reply to: