Re: need sd card backup on r-pi-3b
On Sunday 24 September 2017 16:20:31 Mark Morgan Lloyd wrote:
> On 24/09/17 19:45, Gene Heskett wrote:
> >>> I wouldn't put the manual route command in rc.local, I'd put it in
> >>> the network interface definition as in
> >>>
> >>> allow-hotplug eth0
> >>> iface eth0 inet static
> >>> address 172.27.200.5/24
> >>> post-up route add default gw 172.27.200.1 dev eth0 metric 0
> >>> pre-down route del default gw 172.27.200.1 dev eth0
> >>
> >> Printed to carry out to it, rc.local didn't work at all. I'll try
> >> this
> >
> > next
> >
> >> Thanks.
> >
> > Didn't work, with my addresses, it gave me an empty route -n report.
> > Back to doing it by hand after a reboot.
> > Now trying to get X11 started. X server not in path. :(
>
> There's something badly wrong there. Run ifconfig -a to check that
> your interfaces are named as expected.
rock64@rock64:~$ sudo -i
[sudo] password for rock64:
root@rock64:~# ifconfig -a
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500
inet 192.168.71.2 netmask 255.255.255.0 broadcast
192.168.71.255
inet6 fe80::3c1b:98ff:fe17:e38c prefixlen 64 scopeid 0x20<link>
ether 3e:1b:98:17:e3:8c txqueuelen 1000 (Ethernet)
RX packets 46905 bytes 66972164 (63.8 MiB)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 22393 bytes 1567772 (1.4 MiB)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
device interrupt 39
lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536
inet 127.0.0.1 netmask 255.0.0.0
inet6 ::1 prefixlen 128 scopeid 0x10<host>
loop txqueuelen 1 (Local Loopback)
RX packets 3 bytes 232 (232.0 B)
RX errors 0 dropped 0 overruns 0 frame 0
TX packets 3 bytes 232 (232.0 B)
TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0
Thanks Mark.
Cheers, Gene Heskett
--
"There are four boxes to be used in defense of liberty:
soap, ballot, jury, and ammo. Please use in that order."
-Ed Howdershelt (Author)
Genes Web page <http://geneslinuxbox.net:6309/gene>
Reply to: