DreamPlug U-boot/kernel 3.0 patch status
Jason,
ok, so U-boot 2011.09 is working for me on the DreamPlug with your v8
patch [1]. I had to grab your pre-FDT kernel patch [2] to get the kernel to
recognise the new mach_id.
Is this OK in the interim or do I need anything else? On a first try the
kernel does boot, but a) does not see the external SD card, only the
embedded one and the USB stick I have pluggen in and b) there is a 120
second delay during boot here:
[ 7.009352] sdb: sdb1
[ 7.014203] sd 2:0:0:0: [sdb] Asking for cache data failed
[ 7.019740] sd 2:0:0:0: [sdb] Assuming drive cache: write through
[ 7.025864] sd 2:0:0:0: [sdb] Attached SCSI removable disk
[ 127.189047] libertas_sdio: failed to find firmware (-2)
[ 127.194403] libertas_sdio: probe of mmc0:0001:1 failed with error -2
[ 127.205003] EXT3-fs: barriers not enabled
[ 131.091832] EXT3-fs (sda2): warning: checktime reached, running e2fsck is recommended
I will do some more thorough tests this week, and would also like to flash
the new U-boot to SPI (still booting from UART at the moment), can you
please tell me the exact commands I should be using so that I don't mess
things up?
Thanks,
-mato
[1] http://article.gmane.org/gmane.comp.boot-loaders.u-boot/108752
[2] http://article.gmane.org/gmane.linux.ports.arm.kernel/120507
Reply to: