Re: Step 6, or how to boot into single user mode on a nslu2

["Jeffrey B. Green" <jeff@kikisoso.org>]

Wookey writes:
> +++ Jeffrey B. Green [2010-07-07 10:00 -0400]:
> > I have a couple of slugs both running debian arm and am now very much
> > aware of the fact that squeeze has dropped arm from the distributions in
> > favor of armel. The only migration procedure that I have discovered so
> > far is the one on the ArmEabiHowto, e.g. the section "Migrating arm
> > installation to arm EABI installation". Althought the procedure is more
> > of a "re-install" approach, which is okay I suppose, the rough point in
> > the procedure is step 6 where it says:
> >
> > 6 boot into single user mode and make sure there is no processess running
> >
> > So far, I not found a clear description of that step.
>
> telinit 1

I.e. just drop back into single user mode after booting up. If so, then 
trying it out just now kills my ssh link via dropbear.

> should do the trick. (not tested on my slug)
>
> Wookey

-jeff