On Wed, Oct 7, 2009 at 21:19, Douglas Lopes Pereira
<douglaslopespereira@gmail.com> wrote:
Hi guys,
I'm trying to power up my Sheeva Plug (which is configured to boot
Martin's debian from USB drive) with my USB drive connected over an
USB hub with other devices on it (i.e Usb headset).
Uboot identifies the devices connected but does not recognize my USB
drive and get stuck.
This is what I see from my terminal:
======================= TERMINAL OUTPUT =========================
U-Boot 1.1.4 (May 13 2009 - 13:10:52) Marvell version: 3.4.16
U-Boot code: 00600000 -> 0067FFF0 BSS: -> 006CF100
Soc: 88F6281 A0 (DDR2)
CPU running @ 1200Mhz L2 running @ 400Mhz
SysClock = 400Mhz , TClock = 200Mhz
DRAM CAS Latency = 5 tRP = 5 tRAS = 18 tRCD=6
DRAM CS[0] base 0x00000000 size 256MB
DRAM CS[1] base 0x10000000 size 256MB
DRAM Total size 512MB 16bit width
Flash: 0 kB
Addresses 8M - 0M are saved for the U-Boot usage.
Mem malloc Initialization (8M - 7M): Done
NAND:512 MB
CPU : Marvell Feroceon (Rev 1)
Streaming disabled
Write allocate disabled
USB 0: host mode
PEX 0: interface detected no Link.
Net: egiga0 [PRIME], egiga1
Hit any key to stop autoboot: 0
(Re)start USB...
USB: scanning bus for devices...
USB device not responding, giving up (status=20)
4 USB Device(s) found
scanning bus for storage devices...
======================= TERMINAL OUTPUT =========================
Does anyone know how to boot my system without removing other stuff
from my usb hub?
Thanks for your attention.
Regards,
Douglas
--
To UNSUBSCRIBE, email to debian-arm-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org