How can I mount a USB harddrive to Debian4.0r0/NSLU2
Install debian 4.0 + LAMP +Samba on NSLU2. The debian is in a 2GB flashdrive attached to USB1 port. They work well.
A usb harddrive is pluged to USB 2 port. The enclosure uses cypress USB/ Oxford 1394 chipsets. HDD is maxtor 200GB IDE, formated as NTFS with my windowsXP. The usb HDD was detected by Debian installer. But now the disk2 LED of NSLU2 is off.
How to get it work under Debian? Can I use NTFS in Debain/NSLU2? Can I fdisk it into 2 partations, one for mldonkey, one for other use. Can I use a USB hub to attach two HDD to USB2.
thanks
Here is fstab
# /etc/fstab: static file system information.
#
# <file system> <mount point> <type> <options> <dump> <pass>
proc /proc proc
defaults 0 0
/dev/sda1 / ext3 defaults,errors=remount-ro 0 1
/dev/sda5 none swap sw 0 0
/dev/sda1 /media/usb0 auto rw,user,noauto 0 0
/dev/sda5 /media/usb1 auto rw,user,noauto 0 0
/dev/sdb1
/media/usb2 auto rw,user,noauto 0 0
# UNCONFIGURED FSTAB FOR BASE SYSTEM
and the dmesg
........................
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 3 ports detected
PCI: enabling device 0000:00:01.1 (0140 -> 0142)
ohci_hcd 0000:00:01.1: OHCI Host Controller
ohci_hcd 0000:00:01.1: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:01.1: irq 27, io mem 0x48001000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
PCI: enabling device 0000:00:01.2 (0140 -> 0142)
ehci_hcd 0000:00:01.2: EHCI Host Controller
ehci_hcd 0000:00:01.2: new USB bus registered, assigned bus number 3
ehci_hcd 0000:00:01.2: irq 26, io mem 0x48002000
ehci_hcd 0000:00:01.2: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb3:
configuration #1 chosen from 1 choice
hub 3-0:1.0: USB hub found
hub 3-0:1.0: 5 ports detected
usb 3-1: new high speed USB device using ehci_hcd and address 2
usb 3-1: configuration #1 chosen from 1 choice
SCSI subsystem initialized
Initializing USB Mass Storage driver...
usb 3-2: new high speed USB device using ehci_hcd and address 3
usb 3-2: configuration #1 chosen from 1 choice
scsi0 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 2
usb-storage: waiting for device to settle before scanning
scsi1 : SCSI emulation for USB Mass Storage devices
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usb-storage: device found at 3
usb-storage: waiting for device to settle before scanning
Vendor: Flash Model: Drive UT_USB20 Rev: 0.00
Type:
Direct-Access ANSI SCSI revision: 02
Vendor: Maxtor 6 Model: L200P0 Rev: 0000
Type: Direct-Access ANSI SCSI revision: 00
usb-storage: device scan complete
usb-storage: device scan complete
SCSI device sda: 4030463 512-byte hdwr sectors (2064 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache: write through
SCSI device sda: 4030463 512-byte hdwr sectors (2064 MB)
sda: Write Protect is off
sda: Mode Sense: 00 00 00 00
sda: assuming drive cache:
write through
sda: sda1 sda2 < sda5 >
sd 0:0:0:0: Attached scsi removable disk sda
SCSI device sdb: 398297088 512-byte hdwr sectors (203928 MB)
sdb: Write Protect is off
sdb: Mode Sense: 27 00 00 00
sdb: assuming drive cache: write through
SCSI device sdb: 398297088 512-byte hdwr sectors (203928 MB)
sdb: Write Protect is off
sdb: Mode Sense: 27 00 00 00
sdb: assuming drive cache: write through
sdb: sdb1 sdb2
sd 1:0:0:0: Attached scsi disk sdb
EXT3-fs: INFO: recovery required on readonly filesystem.
EXT3-fs: write access will be enabled during recovery.
kjournald starting. Commit interval 5 seconds
EXT3-fs: recovery complete.
EXT3-fs: mounted filesystem with ordered data mode.
swapped image found
Image loaded to NPE-B Func:0, Rel: 2:1, Status: 82800000
IXP4XX NPE driver Version 0.3.0 initialized
IXP4XX Q Manager 0.2.1 initialized.
input: ixp4xx beeper as
/class/input/input0
ixp4xx_mac driver 0.3.1: eth0 on NPE-B with PHY[1] initialized
Adding 192740k swap on /dev/sda5. Priority:-1 extents:1 across:192740k
EXT3 FS on sda1, internal journal
.............
Ahhh...imagining that irresistible "new car" smell?
Check out
new cars at Yahoo! Autos.
Reply to: