Bug#311968: apache2-common: can't be accessed from ipv4 clients in default configuration
Torok Edwin wrote:
>
> If I run apache2 using it's default config, it binds to the ipv6 address,
> even though I haven't set up an ipv6 connection (sit0 is down, only eth0,
> ppp0, and lo is up).
This is definitely a new one on me. Given that no one else has ever
reported this bug before, and pretty much everyone out there has setups
similar to your (ipv4-only, no ipv6 configured), I'd be curious to know
what's special/different about your setup.
Is there any information you can give us about the oddity of your
configuration that could shed some light on your very unique issue?
After a default apache2 installation, what does "lsof -i TCP | grep
apache" show you?
... Adam
Reply to: