Re: ndiswrapper screwed up again?
Am Mittwoch, 9. August 2006 13:56 schrieb Rafael Rodríguez:
> I'm using 2.6.17-ck1, and the driver still doesn't work for me :)
> I haven't really thought about it that much due to its alpha state, but it
> loads and detects my wlan BUT won't associate with any AP.
That is weired. Just try to add the gateway of the AP
in /etc/network/interfaces. This worked for me. And please check, if the
correct ethx is wlan, if you have wo network-devices. Remember: The Broadcom
card is seen as ethX not as wlanX !
If required, I could send you m /etc/network/interfaces
P.S. I suppose , you have the correct firmware installed. bcm-fwutter does
> So waiting for 2.6.18... That probably won't be out until the end of the
> month (or even September) because Linus is on holidays for three weeks ;)
> Rafael Rodríguez
> On 8/9/06, Hans <email@example.com> wrote:
> > Am Mittwoch, 9. August 2006 12:41 schrieb Rafael Rodríguez:
> > > Hi,
> > >
> > > i've upgraded yesterday to ndiswrapper 1.22 in sid, and upon loading it
> > > "oopses" my kernel. Anyone with the same problem?
> > >
> > > I'm using a Broadcom chip in my HP laptop and can provide backtraces if
> > > someone's is interested...
> > >
> > > Rafael Rodríguez
> > Did you try kernel 2.6.17 ? It has native WLAN Broadcomdriver shipped
> > with,
> > and it is running fine. No more ndiswrapper needed.
> > The native driver has some advantages, as I found out. You can use some
> > software eith it, which could not b eused, if you use wlan with
> > ndiswrapper.
> > Just check the kernel, good luck !
> > Best regards
> > Hans
> > --
> > To UNSUBSCRIBE, email to debian-amd64-REQUEST@lists.debian.org
> > with a subject of "unsubscribe". Trouble? Contact
> > firstname.lastname@example.org