[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: d-i on sarge still not working on my DS20L, for about a year.

No, it doesn't.  However, maybe the overlaps are the cause?  Is each
partition supposed to start at previous end+1?

bnf:/etc/network# fdisk /dev/hda
Detected an OSF/1 disklabel on /dev/hda, entering disklabel mode.

BSD disklabel command (m for help): p

7 partitions:
#       start       end      size     fstype   [fsize bsize   cpg]
  a:        5*     1045*     1040*      ext2
  b:     1045*     5108*     4063*      swap
  d:     5108*    15267*    10158*      ext2
  e:    15267*    21362*     6095*      ext2
  f:    21362*    22403*     1040*      ext2
  g:    22403*   116301     93898*      ext2

btw, I could boot the 2.2.22 and upgrade to 2.6.8, but the built-in e100
driver isn't working, so I may make that my priority now.  This was a
problem way-back-when also in my last attempt to go beyond 2.6.5.

lspci shows two difference "rev"?

bnf:/etc/network# lspci
0000:00:03.0 SCSI storage controller: LSI Logic / Symbios Logic 53c1010
66MHz  Ultra3 SCSI Adapter (rev 01)
0000:00:04.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100]
(rev 0c)
0000:00:07.0 ISA bridge: ALi Corporation M1533 PCI to ISA Bridge [Aladdin
IV] (rev c3)
0000:00:10.0 IDE interface: ALi Corporation M5229 IDE (rev c2)
0000:00:11.0 Non-VGA unclassified device: ALi Corporation M7101 Power
Management  Controller [PMU]
0001:01:03.0 Ethernet controller: Intel Corp. 82557/8/9 [Ethernet Pro 100]
(rev 08)

> Hi Dan,
> Does your partition table include a Tru64-style full disk slice?
> Unfortunately, the sarge version of partman treats overlapping partitions
> as
> an invalid partition table.
> --
> Steve Langasek
> postmodern programmer

Reply to: