Re: PCC error
On Fri, Sep 07, 2001 at 10:51:11AM -0700, Rick Eicher II wrote:
> I have to to enter them but it tells me what the defaults are.
OK, different from my manual.
> This pcb is about two inches wide and four inches long? If so the fuse is
> green? It is bad. It will not pass current.
That's the pcb, don't know what colour your fuse might be - sorry, I don't
have oneI can look at right now.
> This would cause the pcc command to throw out the " scsi port reset signal
> is active" error?
Unpowered terminators might well pull the scsi bus reset line down which
might result in that msg.
Richard
Reply to: