Re: PCC error
On Fri, Sep 07, 2001 at 08:55:45AM -0700, Rick Eicher II wrote:
> Also I do have all of the terminating blocks in place. I have replaced the
> scsi cable. Not sure if I know what fuse you are referring to Richard Hirst.
> I assume that a pcb is the card plugged into the back plate that the scsi
> cable plugs into??
Yes, that is the pcb. IIRC, there is a small fuse on that pcb. Much
smaller than a typical fuse, perhaps 10mm long and 3mm diameter, and
with wire lead ends - so it looks more like a resistor. Anyway, if that
fuse exists on your pcb, and is blown, then there will be no power on
those terminators. Might be worth trying ENV;D to reset the nvram
contents too.
Richard
Reply to: