please decrypt cdrecord's error message
Hi,
having used (earlier) versions of cdrecord on the very same drive and
media brand, I got the following errors today (on two medias)
(This is with Linux kernel 2.6.26)
Cdrecord-ProDVD-ProBD-Clone 2.01.01a55 (i686-pc-linux-gnu) Copyright (C) 1995-2008 Jörg Schilling
TOC Type: 1 = CD-ROM
scsidev: '/dev/hdb'
devname: '/dev/hdb'
scsibus: -2 target: -2 lun: -2
Warning: Open by 'devname' is unintentional and not supported.
Linux sg driver version: 3.5.27
Using libscg version 'schily-0.9'.
Driveropts: 'burnfree'
SCSI buffer size: 64512
atapi: 1
Device type : Removable CD-ROM
Version : 0
Response Format: 2
Capabilities :
Vendor_info : 'HL-DT-ST'
Identifikation : 'DVDRAM GSA-4167B'
Revision : 'DL11'
Device seems to be: Generic mmc2 DVD-R/DVD-RW/DVD-RAM.
Current: DVD-R sequential recording
Profile: DVD-RAM
Profile: DVD-R sequential recording (current)
Profile: DVD-R/DL sequential recording
Profile: DVD-R/DL layer jump recording
Profile: DVD-RW sequential recording
Profile: DVD-RW restricted overwrite
Profile: DVD+RW
Profile: DVD+R
Profile: DVD+R/DL
Profile: DVD-ROM
Profile: CD-R
Profile: CD-RW
Profile: CD-ROM
Profile: Removable Disk
Using generic SCSI-3/mmc-2 DVD-R/DVD-RW/DVD-RAM driver (mmc_dvd).
Driver flags : NO-CD DVD MMC-3 SWABAUDIO BURNFREE
Supported modes: PACKET SAO
Drive buf size : 1114112 = 1088 KB
Drive pbuf size: 1966080 = 1920 KB
Drive DMA Speed: 11772 kB/s 66x CD 8x DVD 2x BD
FIFO size : 67108864 = 65536 KB
Track 01: data 0 MB padsize: 30 KB
Total size: 0 MB = 300 sectors
Current Secsize: 2048
Total power on hours: 6656
Blocks total: 2298496 Blocks current: 2298496 Blocks remaining: 2298196
Reducing transfer size from 64512 to 32768 bytes.
Starting to write CD/DVD/BD at speed 4 in real SAO mode for single session.
Last chance to quit, starting real write 0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
BURN-Free is ON.
Starting new track at sector: 0
Track 01: 0 MB written.
Track 01: writing 600 KB of pad data.
/usr/local/bin/cdrecord: Success. write_g1: scsi sendcmd: no error
CDB: 2A 00 00 00 00 00 00 00 10 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: F0 00 05 00 00 00 00 10 2A 00 00 0C 21 00 00 00
Sense Key: 0x5 Illegal Request, Segment 0
Sense Code: 0x21 Qual 0x00 (logical block address out of range) Fru 0x0
Sense flags: Blk 0 (valid)
resid: 32768
cmd finished after 0.001s timeout 200s
write track pad data: error after 0 bytes
BFree: 1088 K BSize: 1088 K
Track 01: Total bytes read/written: 32768/0 (0 sectors).
Writing time: 8.876s
Average write speed 0.1x.
Fixating...
Fixating time: 20.623s
/usr/local/bin/cdrecord: fifo had 1 puts and 1 gets.
/usr/local/bin/cdrecord: fifo was 0 times empty and 0 times full, min fill was 100%.
Many thanks for a hint,
Helmut.
--
Helmut Jarausch
Lehrstuhl fuer Numerische Mathematik
RWTH - Aachen University
D 52056 Aachen, Germany
Reply to: