RE: Sarge install cd mounting problem
I want to do this but ran into one snag while trying. When I try to
add the router address "route add default 192.168.0.1 eth0" I get an error
"Usage: route [{add|del|delete}]". Was that the correct syntax you gave me
bear in mind I am still learning every step of the way. Thanks for your
help.
-JP
-----Original Message-----
From: Jurij Smakov [mailto:jurij@wooyd.org]
Sent: Tuesday, December 07, 2004 7:51 PM
To: debian-sparc@lists.debian.org
Subject: Re: Sarge install cd mounting problem
On Mon, 6 Dec 2004, Jason Parvu wrote:
> I downloaded sarge and after I boot into the install and it gets to the
> "Detect and mount CD-ROM" stage I get an error message "Your installation
> CD-ROM couldn't be mounted. This probably means that the CD-ROM is not in
> the drive...bla bla bla" I have tried this on a sparc 10 and a sparc 5
with
> different CD drive each. Any ideas?
Hi,
This is a known issue with the RC2 installer, mentioned in the errata [0].
The failure is due to the missing isofs.o module on sparc32, the fix is on
its way (not yet fixed in daily builds as of today, December 7th). If you
feel adventurous, here's a workaround:
* Start installation and continue until the error message "CD-ROM cannot
be mounted". Return to the d-i main menu and start a shell.
* At this point the module for your network card should be loaded (check
with lsmod). You need to set up the networking manually, by issuing the
commands:
# ifconfig eth0 gw 192.168.0.1 netmask 255.255.255.0 192.168.0.11 up
# route add default 192.168.0.1 eth0
You have to replace the gateway IP addresses (the one following gw in
the first command and the one in the second command), netmask and the IP
adress of the machine in the first command by correct values.
* Set up the domain name resolver by running
# echo 'nameserver 192.168.0.1' > /etc/resolv.conf
Again, you have to replace the IP address of the nameserver by your
correct value.
* Get the isofs.o module by running
# wget http://www.wooyd.org/debian/isofs/isofs.o
* Make the appropriate directories and copy the module into place:
# mkdir /lib/modules/2.4.27-1-sparc32/kernel/fs
# mkdir /lib/modules/2.4.27-1-sparc32/kernel/isofs
# cp isofs.o /lib/modules/2.4.27-1-sparc32/kernel/isofs/
* Load the isofs module:
# depmod -a
# modprobe isofs
* Exit the shell, return to the d-i's main menu and retry the option
"Detect and mount CD-ROM". It should now mount and the installation
should continue.
[0] http://www.debian.org/devel/debian-installer/errata
Good luck,
Jurij Smakov jurij@wooyd.org
Key: http://www.wooyd.org/pgpkey/ KeyID: C99E03CC
--
To UNSUBSCRIBE, email to debian-sparc-REQUEST@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact
listmaster@lists.debian.org
Reply to: