Re: X on a u10
On Sat, Aug 19, 2000 at 03:00:19PM +0200, Andreas Larsson wrote:
> Hello,
> I have been trying to set the default resolution on my u10 whith a
> creator 3d card. I have now come to understand that i have to get the
> Xserver running to do that, which isnt a problem since i was planing to
> run X anyway. However when i try to start the Xsun24 server it dies
> whith the folowing message.
>
> ultra:~# Xsun24
> (using VT number 7)
>
> FFB: Detected Creator/Creator3D, using acceleration unless -noFFB.
> FFB: Detected FFB2+/vertical, Single-buffered.
> PEXExtensionInit: Couldn't open default PEX font file Roman_M
> sunMouseProc ioctl VUIDGFORMAT: Invalid argument
>
> Fatal server error:
> failed to initialize core devices
> ultra:~#
>
> it sounds like the mouse i broken dont you say? i can not figure out
> what mouse protocoll to use, i have tried ps2 and ms whithout luck.
where did you set the mouse protocol ?
which kernel version ?
what's the version of the xserver-xsun24 package ?
where is /dev/mouse pointing to ?
Christian
--
Christian Meder, email: meder@isr.uni-stuttgart.de
What's the railroad to me ?
I never go to see
Where it ends.
It fills a few hollows,
And makes banks for the swallows,
It sets the sand a-blowing,
And the blackberries a-growing.
(Henry David Thoreau)
Reply to:
- References:
- X on a u10
- From: Andreas Larsson <andla028@student.liu.se>