Re: Patch for IBM PRePs
begin On Wed, Jul 03, Tom Rini wrote:
> On Wed, Jul 03, 2002 at 09:02:32PM +0200, Olaf Hering wrote:
>
> > On Mon, Jul 01, Tom Rini wrote:
> >
> > > Lemme know if you still have the correct ammount of memory reported
> > > still. Thanks.
> >
> > ocan you provide a new patch for _devel? I used that one and it doesnt
> > compile
>
> D'oh. I forgot to add <asm/bootinfo.h> to prep_setup.c. New patches
> attached.
It does detect the memory, seems to work fine on 43p 140.
But it seems zImage.initrd.prep is broken since at least 2.4.16:
loaded at: 00600400 00879FCC
relocated to: 00800000 00A79BCC
board data at: 00231370 00237D7C
relocated to: 00A70130 00A76B3C
zimage at: 0080A400 009684D5
initrd at: 00969000 00A6FBCC
avail ram: 00400000 00800000
Linux/PPC load: console=ttyS0,9600 start_shell
Uncompressing Linux...done.
Now booting the kernel
Memory BAT mapping: BAT2=256Mb, BAT3=128Mb, residual: 256Mb
Total memory = 384MB; using 1024kB for hash table (at c0400000)
...
RAMDISK: Compressed image found at block 0
invalid compressed format (err=2)<6>Freeing initrd memory: 1050k freed
...
Memory BAT mapping: BAT2=256Mb, BAT3=128Mb, residual: 256Mb
Total memory = 384MB; using 1024kB for hash table (at c0400000)
Linux version 2.4.19-rc1 (olaf@nectarine) (gcc version 2.95.3 20010319 (2.95.4 CVS + prerelease/franzo/20010912)) #7 Tue Jul 9 15:15:51 CEST 2002
PReP architecture
IBM planar ID: 000000d5
MPIC at 0xf7fc0000 (0x37fc0000), length 0x00040000 mapped to 0xeffc0000
On node 0 totalpages: 98304
zone(0): 98304 pages.
zone(1): 0 pages.
zone(2): 0 pages.
Kernel command line: console=ttyS0,9600 start_shell
OpenPIC Version 1.0 (4 CPUs and 16 IRQ sources) at effc0000
time_init: decrementer frequency = 16.617493 MHz
Console: colour dummy device 80x25
Calibrating delay loop... 398.13 BogoMIPS
Memory: 382832k available (2324k kernel code, 1032k data, 308k init, 0k highmem)
Dentry cache hash table entries: 65536 (order: 7, 524288 bytes)
Inode cache hash table entries: 32768 (order: 6, 262144 bytes)
Mount-cache hash table entries: 8192 (order: 4, 65536 bytes)
Buffer-cache hash table entries: 32768 (order: 5, 131072 bytes)
Page-cache hash table entries: 131072 (order: 7, 524288 bytes)
POSIX conformance testing by UNIFIX
PCI: Probing PCI hardware
Bridge 00:17.0 resource 0 was deactivated by firmware
Bridge 00:17.0 resource 1 was deactivated by firmware
Bridge 00:17.0 resource 2 was deactivated by firmware
Setting PCI interrupts for a "IBM 43P-140 (Tiger1)"
PCI: Cannot allocate resource region 0 of device 00:0b.0
PCI: Cannot allocate resource region 0 of device 00:0c.0
PCI: Cannot allocate resource region 0 of device 00:10.0
PCI: moved device 00:0b.0 resource 0 (101) to 1000
PCI: moved device 00:0c.0 resource 0 (101) to 1020
PCI: moved device 00:10.0 resource 0 (101) to 1400
Linux NET4.0 for Linux 2.4
Based upon Swansea University Computer Society NET3.039
Initializing RT netlink socket
Thermal assist unit not available
Starting kswapd
Journalled Block Device driver loaded
Detected PS/2 Mouse Port.
pty: 256 Unix98 ptys configured
Serial driver version 5.05c (2001-07-08) with MANY_PORTS SHARE_IRQ SERIAL_PCI enabled
ttyS00 at 0x03f8 (irq = 4) is a 16550A
ttyS01 at 0x02f8 (irq = 3) is a 16550A
Uniform Multi-Platform E-IDE driver Revision: 6.31
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
ide-floppy driver 0.99.newide
Floppy drive(s): fd0 is 2.88M
FDC 0 is a National Semiconductor PC87306
RAMDISK driver initialized: 16 RAM disks of 128000K size 1024 blocksize
loop: loaded (max 8 devices)
pcnet32.c:v1.27a 10.02.2002 tsbogend@alpha.franken.de
PCI: Enabling device 00:0c.0 (0000 -> 0003)
pcnet32: PCnet/PCI II 79C970A at 0x1020, 00 06 29 21 17 5a assigned IRQ 22.
eth0: registered as PCnet/PCI II 79C970A
pcnet32: 1 cards_found.
ide-floppy driver 0.99.newide
SCSI subsystem driver Revision: 1.00
PCI: Enabling device 00:10.0 (0016 -> 0017)
sym.0.16.0: setting PCI_COMMAND_PARITY...
sym0: <825a> rev 0x13 on pci bus 0 device 16 function 0 irq 23
sym0: No NVRAM, ID 7, Fast-10, SE, parity checking
sym0: SCSI BUS has been reset.
scsi0 : sym-2.1.17a
Vendor: IBM Model: CDRM00203 !K Rev: 8B08
Type: CD-ROM ANSI SCSI revision: 02
sym0:5: FAST-10 WIDE SCSI 20.0 MB/s ST (100.0 ns, offset 8)
Vendor: IBM Model: DCAS-32160W !# Rev: S63A
Type: Direct-Access ANSI SCSI revision: 02
sym0:6: FAST-10 WIDE SCSI 20.0 MB/s ST (100.0 ns, offset 8)
Vendor: IBM Model: DCAS-32160W !# Rev: S63A
Type: Direct-Access ANSI SCSI revision: 02
sym0:5:0: tagged command queuing enabled, command queue depth 16.
sym0:6:0: tagged command queuing enabled, command queue depth 16.
scsi1 : SCSI host adapter emulation for IDE ATAPI devices
mesh: configured for synchronous 5 MB/s
Attached scsi disk sda at scsi0, channel 0, id 5, lun 0
Attached scsi disk sdb at scsi0, channel 0, id 6, lun 0
SCSI device sda: 4226725 512-byte hdwr sectors (2164 MB)
Partition check:
sda: sda1 sda2 sda3
SCSI device sdb: 4226725 512-byte hdwr sectors (2164 MB)
sdb: sdb1
Attached scsi CD-ROM sr0 at scsi0, channel 0, id 3, lun 0
sym0:3: FAST-10 SCSI 10.0 MB/s ST (100.0 ns, offset 8)
sr0: scsi-1 drive
Uniform CD-ROM driver Revision: 3.12
PowerMac Z8530 serial driver version 2.0
Macintosh non-volatile memory driver v1.0
apm_emu: Requires a machine with a PMU.
usb.c: registered new driver usbdevfs
usb.c: registered new driver hub
usb.c: registered new driver hiddev
usb.c: registered new driver hid
hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <vojtech@suse.cz>
hid-core.c: USB HID support drivers
mice: PS/2 mouse device common for all mice
NET4: Linux TCP/IP 1.0 for NET4.0
IP Protocols: ICMP, UDP, TCP, IGMP
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP: Hash tables configured (established 32768 bind 32768)
NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.
RAMDISK: Compressed image found at block 0
invalid compressed format (err=2)<6>Freeing initrd memory: 1050k freed
cramfs: wrong magic
reiserfs: checking transaction log (device 08:03) ...
Using r5 hash to sort names
ReiserFS version 3.6.25
VFS: Mounted root (reiserfs filesystem) readonly.
Freeing unused kernel memory: 308k init 60k pmac 8k chrp 16k openfirmware
Adding Swap: 519240k swap-space (priority 42)
kjournald starting. Commit interval 5 seconds
EXT3 FS 2.4-0.9.17, 10 Jan 2002 on sd(8,17), internal journal
EXT3-fs: mounted filesystem with ordered data mode.
--
$ man clone
BUGS
Main feature not yet implemented...
--
To UNSUBSCRIBE, email to debian-powerpc-request@lists.debian.org
with a subject of "unsubscribe". Trouble? Contact listmaster@lists.debian.org
Reply to: