mike wrote:
I don't know this switch but why does g19 have Mode "On" and g21 have Mode "Off"?Here's all the information I think could possibly be relevant... does anything look out of place here? and the two ports on the switch: switch01# show int st Flow Link Back Mdix Port Type Duplex Speed Neg ctrl State Pressure Mode ........ ............ ...... ..... ........ .... ........... ........ ....... g19 1G-Copper Full 1000 Enabled Off Up Disabled On g21 1G-Combo-C Full 1000 Enabled Off Up Disabled Off
Also, why not try making the Mdix type the same?
Both ports full duplex, speed 1000, flow control off, neg enabled, state up, back pressure disabled, and MDI/MDIX is different (don't think that should make a difference?) On 1/30/06, Anthony DeRobertis <anthony@derobert.net> wrote:Check to make sure that B is operating in 1000mbps, full duplex, using ethtool, and check to make sure the switch agrees. Duplex mismatches will kill any ethernet link.