General LSB-os question
Anyone:
In about 5 or 6 test cases you will get a FAILURE on the test case but the
information that is listed is only one line which says something like
"aio_cancel succeeded". No other information is listed. After going into
the individual test cases that had this, I understand that the test was for
a error condition and that you expected a failure and when it didn't fail
that is an error. My only concern is what is put into the log. It does
not give any other information. So it isn't clear until you actual go into
the test cases and read what it is doing to understand what happen.
On a few more that succeeded line appears and then an error line appears
afterwards stating what it expected to see and what it actually got. Is
there any way we can have all the test cases do it the second way. In
which an error line does come out so we know what is happening. If not,
can we change the error message from "... succeeded" to "... succeeded but
we expected an error". Or something like that so a person looking at the
log will know what is happening.
Stephanie
Linux Technology Center
IBM, 11400 Burnet Road, Austin, TX 78758
Phone: (512) 838-9284 T/L: 678-9284 Fax: (512) 838-3882
E-Mail: sglass@us.ibm.com
Reply to: