[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: qt.network.ssl problems (OT?)



On Tue, Jun 20, 2023 at 2:18 PM Patrick Wiseman <pwiseman@gmail.com> wrote:
On Tue, Jun 20, 2023, 2:02 PM gene heskett <gheskett@shentel.net> wrote:
On 6/20/23 13:33, Patrick Wiseman wrote:
> Hello, all:
>
> This may be a little off-topic, in which case, apologies, but there's so
> much knowledge here, maybe someone can help.
>
> I recently acquired a Creality 3D printer, and Creality has supplied an
> AppImage to operate it. When I execute it, I get these errors and a
> segmentation fault:
>
> qt.network.ssl: QSslSocket: cannot resolve EVP_PKEY_base_id
> qt.network.ssl: QSslSocket: cannot resolve SSL_get_peer_certificate
> Segmentation fault
>
> Googling suggests this is a common problem for developers using Qt, but I
> didn't find any obvious solution. Help would be much appreciated.
>
> Patrick

That AppImage is probably a copyright violation copy of an old and
outdated klipper, Please install and use the real thing, many bugs have
been treated since it was forked and put under their proprietary
umbrella. I have an S1 coming tomorrow, but it will get run by the real
thing.

Thanks , but the AppImage is what it is and the firmware on the K1 printer is also what it is. Anything else I can do?


An acquaintance tells me it runs fine on Linux Mint 21.1 so what's different about Debian 12 (bookworm)? And isn't an AppImage supposed to run anywhere?

Patrick
 

Reply to: