Re: Ipv6, but no Ipv4 after reboot
On 12/9/20 4:54 PM, Dominique Dumont wrote:
> Hi
>
> I've run in a weird problem. After a reboot, only Ipv6 address is setup on my
> wired network card.
>
> The workaround is fairly simple: disconnect and reconnect with network
> manager. Note that Ipv4 is brought up after suspend/resume
>
> Still, this is cumbersome. I've found no obvious problems in the logs.
>
> Where should I look to investigate this problem ?
>
Hi,
try to edit the connection parameters in network manager and check the
following checkbox "IPv4 is required for this connection" on "IPv4" tab.
Kind regards
Georgi
Reply to: