Re: bridges with multiple static IPs or DHPC - how to configure?
On Wed, 4 Jun 2014 20:00:49 +0200
Steffen Dettmer <steffen.dettmer@gmail.com> wrote:
> I tried many combinations, but I didn't find any working one.
From what I understand, bridge act as a too low level
to do what you want.
However, I was able to add another I/F to my own bridge
(br0 basically aggregates eth0 & wlan0 under 192.168.1.200)
using this syntax:
ifconfig br0:1 192.168.1.201
…
br0 Link encap:Ethernet HWaddr 00:19:66:16:bc:85
inet addr:192.168.1.200 Bcast:192.168.1.255 Mask:255.255.255.0
inet6 addr: fe80::219:66ff:fe16:bc85/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:11806935 errors:0 dropped:0 overruns:0 frame:0
TX packets:8818044 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:0
RX bytes:13733814175 (12.7 GiB) TX bytes:3826222577 (3.5 GiB)
br0:1 Link encap:Ethernet HWaddr 00:19:66:16:bc:85
inet addr:192.168.1.201 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
…
--
SnaKe> Nice demoiselle on this picture ^^ A female you fornicated?
Arthur> It's my sister asshole '
BoB_Le_Rasta> It doesn't answer the question...
Reply to: