Re: Owncloud at home and bandwidth
-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1
On 19/06/2013 9:56, Stan Hoeppner wrote:
> On 6/19/2013 2:16 AM, Mérof 42 wrote:
>
>> Actually I use wondershaper to limit upload on eth0 at 512kb/s, but it is limited also for my lan, it is silly.
>>
>> I'd like to limit upload only for external request, but not for my lan. Do you have any idea how can I do that?
>
> Traffic shaping of this type is typically done at the edge router. You simply plug in the LAN IP and set the in/out rate limits
> either wholesale or by service type. The router obviously must support this. Unfortunately not many consumer routers do. So you
> either move up to a more expensive commercial unit, or build another Linux box and install the appropriate software, such as
> wondershaper. Your current problem is that you're trying to do too much within a single host. It can probably be done, but a whole
> lot of hacking will be required.
>
It's possible to assign multiple ip addresses to a nic, so that might be
a way to work around the problem of wondershaper?
- --
Benedict Verheyen Debian, Python and Django user
GnuPG Public Key 0x712CBB8D
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.4.11 (MingW32)
Comment: Using GnuPG with Thunderbird - http://www.enigmail.net/
iEYEARECAAYFAlHBaiUACgkQ6YPsX3Esu43QsQCgseJLK76zxNtKlriIlqihiluR
7ssAoJ3d61/AAXLADsUVA8UmiqIijP10
=YR8D
-----END PGP SIGNATURE-----
Reply to: