[Date Prev][Date Next] [Thread Prev][Thread Next] [Date Index] [Thread Index]

Re: [OT] Good quality hair dryer needed for Squeeze



On 12/11/2012 07:50 AM, Kelly Clowers wrote:
On Mon, Dec 10, 2012 at 5:32 PM, Mark Panen<mark.panen@gmail.com>  wrote:
Hi,

I am replying to all, not used to sitting in the dark with the light of the
notebook to type only, Out here in the sticks there are always power
failures when it rains. I normally use pop, not used to gmail., the mobo is
two years old a midrange board with SATA 6 and USB 3.0, an ASUS, I also
thought it was the Ocean air and humidity but my other ASUS mobo has no
hassles. I have enough lightining protection to protect I dpn't know what
and always unplug before storm, I think I was naughty when I fist received
the board and overclocked it from 2.8 to 3.8 even though the temps where
fine ans I have a fantastic Zalman aftercooler. devede ran quite stable a
sdid prime sorry for the s[peeling my UPS is about to go flat
Well, that was rather rambling, but to me is sounds like there is a
fault in your motherboard. My guess is the heat from your hairdryer
(how did you figure that out anyway?!) either dries out some bit that
overly sensitive to moisture, or causes thermal expansion of some part
that does not make enough contact otherwise... although in the second
case,  it should be more about ambient temperature, not about if there
was a rain storm.

Two years old, huh? So the warranty is.probably well over. I would say
just get a new Mobo.

Cheers,
Kelly Clowers


Hi Mark,

The first thing I would do is run a post check on the motherboard. If you are lucky your board has a built in post card. If not, you will have to buy one. They are nice to have around for such things. In case you are not familiar with post cards they have a numeric readout that ratchets up through the motherboards post process. The final number displayed can be looked up in a table that will tell you where and probably why the process failed. I would advise researching the post process on the net. If yours is built in ( like my intel i5-750 board) then instructions will be in your board manual. Intermittant problems are a bitch.

Gary R.


Reply to: