Re: Set Up a server using Public IP Addresses on debian
Hi
> after changed gateway to router IP (41.134.19.89), the command
> ifconfig it showing eth1 now but; ping doesn’t work
The use of "eth1" suggests that you have more than one Ethernet-port
in your server (the first one usually is eth0). Are you sure you have
plugged the cable into the correct port? When it's fine and dandy the
port is shown as UP in ifconfig, like:
eth0 Link encap:Ethernet HWaddr 52:54:00:e2:58:72
inet addr:X.Y.168.78 Bcast:X.Y.168.127 Mask:255.255.255.192
inet6 addr: 2001:X:Y:100:5054:ff:fee2:5872/64 Scope:Global
inet6 addr: fe80::5054:ff:fee2:5872/64 Scope:Link
inet6 addr: 2001:X:Y:100::78/64 Scope:Global
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
^^^^
RX packets:60737 errors:0 dropped:0 overruns:0 frame:0
TX packets:24256 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:1000
RX bytes:40895939 (39.0 MiB) TX bytes:3110522 (2.9 MiB)
--
Pelle
RFC1925, truth 11:
Every old idea will be proposed again with a different name and
a different presentation, regardless of whether it works.
Reply to: