Re: kernel
On Tuesday 19 April 2011 17:38:54 Homer Simpson wrote:
> Hello!
>
Hi,
Did you follow the howto from easybcd? I copy it bellow for you to check:
Vista before Linux
EasyBCD makes installing Linux after you have Windows Vista up-and-running a
breeze. These steps assume you have Windows Vista properly installed and
booting, and are looking to install Linux on a second hard drive or partition.
These steps also assume that you are using the default Windows Vista
bootloader, and don't manually change the active partition around. If you had
Linux installed before you installed Windows Vista, scroll down to the next
section.
Put the Linux CD in the drive, and start the installation normally.
When prompted to set up the bootloader, make sure you specify to install
LILO, GRUB, or whatever to the bootsector of the partition that Linux is being
installed to and not the MBR of your hard drive.
Finish the Linux installation, take the CD out of the drive, and reboot.
At this point, you'll go straight back to Windows Vista. Don't panic,
everything is OK - you'll be in Linux soon enough!
Turn on EasyBCD, go to the "Add/Remove Entries" screen and pick Linux from
the tabs at the top.
Pick the appropriate bootloader from the drop-down menu (either GRUB or
LILO),
Give the entry a user-friendly name (and if you want to keep "NST Linux
Loader" as the text, we won't say no!)
The hardest part of this mind-numbingly difficult exercise (/sarcasm) is
choosing the correct hard drive and partition numbers that correspond to the
partition you installed Linux (and most importantly, the bootloader) to.
In EasyBCD (and Windows in general), drive numbers start at 0, and
partitions start at 1. So the second partition of the first drive would be 0,
2.
Press "Add Entry" and reboot.
When the Vista bootloader asks you what OS you'd like to boot into, select
Linux to continue the first-run configuration for your brand-spanking-new Linux
install.
Thierry
Reply to:
- References:
- kernel
- From: Homer Simpson <escrevaprohomer@gmail.com>