Re: Allowing network printing through Arno's IP Tables

[AG <computing.account@googlemail.com>]

On 29/12/10 16:17, Camaleón wrote:
> On 28/12/10 15:02, Camaleón wrote:
>    
> > > I'm not very good at "firewalling" but I guess you will have to put
> > > your internal network inside the "trusted" side. By performing a quick
> > > read on the Arno's IP tables manual
> > > ("/usr/share/doc/arno-iptables-firewall/ README.gz") I suppose it
> > > should be set using "FULL_ACCESS_HOSTS" variable. If that works, then
> > > you can fine-tune the rule and allow access only to the desired host in
> > > the required port.
> > >        
> Try to set the variable I said on my previous post, adjust it to fit your
> needs and reload the firewall service, then test Cups again. Basically,
> what this variable should do is telling iptables "hey, "eth0" manages my
> lan traffic so reject all the external connections (from remote-to-lan)
> but relax the rules within the internal one (lan-to-lan)."
>
>    

I'll try this again in a bit and come back to you.

> Hint: "readme" file has a "quick setup" section with some useful tips for
> each usage scenario.
>
> Greetings,
>
>    

Thanks as always

AG