Re: ehci_hcd has to be manually reloaded for USB 2.0 printer
This problem is not isolated to ehci_hcd. I am able to print with just ohci_hcd or uhci_hcd, but in either case the module has to be loaded AFTER the printer is on.
There must be a simple fix to this. Can anyone help?
--- On Thu, 2/18/10, Jen Craigson <jenniscomputer@ymail.com> wrote:
> From: Jen Craigson <jenniscomputer@ymail.com>
> Subject: ehci_hcd has to be manually reloaded for USB 2.0 printer
> To: debian-user@lists.debian.org
> Date: Thursday, February 18, 2010, 5:44 PM
> Hi everybody,
>
> Well I finally made the upgrade to Lenny, and my USB
> printers only work when the ehci_hcd module is loaded after
> the printer is on. If I set it to load a boot and the
> printer's off, I have to "rmmod ehci_hcd; modprobe ehci_hcd"
> once the printer is on again before it will work.
>
> Before the upgrade to Lenny, everything was going fine. I
> have an HP
> LaserJet 4MPlus connected with a parallel-to-USB cable.
> CUPS is fine. But if ehci_hcd isn't loaded (or if it's
> loaded before the printer is one), when I send a print job
> it's always just "processing" forever, and nothing is
> actually sent to the printer until that module gets
> reloaded.
>
> Is there a way to make it automagically reload when a USB
> printer goes on?
>
> Or is there another fix to this problem?
>
> I appreciate the help. This has me stumped!
>
> THANK YOU SO MUCH!
>
> Jen
>
>
>
>
>
Reply to: