Re: Installing a Broadcom 4312 rev 02 wifi card

[Celejar <celejar@gmail.com>]

On Fri, 27 Feb 2009 17:14:55 -0800
consultores1 <consultores1@gmail.com> wrote:

> El vie, 27-02-2009 a las 16:22 -0500, Celejar escribió:
> > On Fri, 27 Feb 2009 15:39:55 +0100
> > Korrignu <korrignu@gmail.com> wrote:
> > 
> > ...
> > 
> > 
> > > 06:00.0 Network controller: Broadcom Corporation BCM4312 802.11b/g (rev 01)
> > 
> > ...
> > 
> > > [  630.553689] Broadcom 43xx driver loaded [ Features: PMLR,
> > > Firmware-ID: FW13 ]
> > > 
> > > it seems weird that there is only one line about the b43 module...
> > 
> > The driver is definitely not picking up the card.  Here's what it should look like:
> > 
> > [ 2620.611136] b43-phy2: Broadcom 4318 WLAN found (core revision 9)
> > [ 2620.626037] b43-phy2 debug: Found PHY: Analog 3, Type 2, Revision 7
> > [ 2620.626062] b43-phy2 debug: Found Radio: Manuf 0x17F, Version 0x2050, Revision 8
> > [ 2620.636899] phy2: Selected rate control algorithm 'minstrel' 
> > [ 2620.637796] Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ]
> 
> It is well documented that b43 + bcm43xx at the same box create
> conflicts. It looks as if you have both installed, do you?

I do not.  'Broadcom 43xx' does not refer to bcm43xx, and b43 is
working fine.  [I'm not the OP, who's experiencing problems.]

Celejar
--
mailmin.sourceforge.net - remote access via secure (OpenPGP) email
ssuds.sourceforge.net - A Simple Sudoku Solver and Generator