Fidre channel array
Hello everyone
I am a real newby to linux, not just debian.
I have an old compaq 6500 with 2 fibre channel arrays insalled.
I have installed deb 4.0R5 on the server.
When I do a lspci the 2 adapters appear on the list of devices.
server1:~# lspci
00:01.0 PCI bridge: IBM IBM27-82351 (rev 07)
00:02.0 PCI bridge: Digital Equipment Corporation DECchip 21152 (rev 03)
00:0b.0 PCI Hot-plug controller: Compaq Computer Corporation PCI Hotplug
Controller (rev 04)
00:0c.0 System peripheral: Compaq Computer Corporation Advanced System
Management Controller
00:0d.0 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 14)
00:0d.1 SCSI storage controller: LSI Logic / Symbios Logic 53c875 (rev 14)
00:0e.0 VGA compatible controller: ATI Technologies Inc 3D Rage IIC 215IIC
[Mach64 GT IIC] (rev 7a)
00:0f.0 ISA bridge: Intel Corporation 82371AB/EB/MB PIIX4 ISA (rev 02)
00:0f.1 IDE interface: Intel Corporation 82371AB/EB/MB PIIX4 IDE (rev 01)
00:0f.2 USB Controller: Intel Corporation 82371AB/EB/MB PIIX4 USB (rev 01)
00:0f.3 Bridge: Intel Corporation 82371AB/EB/MB PIIX4 ACPI (rev 02)
00:10.0 Host bridge: Intel Corporation 450NX - 82451NX Memory & I/O
Controller (rev 03)
00:12.0 Host bridge: Intel Corporation 450NX - 82454NX/84460GX PCI
Expander Bridge (rev 02)
00:14.0 Host bridge: Intel Corporation 450NX - 82454NX/84460GX PCI
Expander Bridge (rev 02)
01:00.0 Mass storage controller: Compaq Computer Corporation Smart-2/P
RAID Controller (rev 03)
02:04.0 Ethernet controller: Intel Corporation 82557/8/9 [Ethernet Pro
100] (rev 05)
02:05.0 Ethernet controller: Intel Corporation 82557/8/9 [Ethernet Pro
100] (rev 05)
04:02.0 Network controller: Compaq Computer Corporation Fibre Channel Host
Controller (rev 03)
04:04.0 Network controller: Compaq Computer Corporation Fibre Channel Host
Controller (rev 03)
04:0b.0 PCI Hot-plug controller: Compaq Computer Corporation PCI Hotplug
Controller (rev 04)
The adapters already have disk arrays attached.
What I am wanting to know is how do I use/access/setup these devices so
that I can access/use the disk arrays attached to the devices.
Sorry if this is a basic question, but I really am new to linux and don't
have a single clue.
Regards
Fred
Reply to: