Re: Problem with udev rules under etch
Hi,
In article <[🔎] 462C8D8D.3090406@noctus.net>,
Mathias Brodala<info@noctus.net> wrote:
> How do you expect your rule to match these properties?
>
> You say:
>
>> SUBSYSTEMS=3D=3D"scsi"
>
> But it is 'SUBSYSTEM=3D=3D"block"' instead.
The bit that contains the 'ZIP 100' is the 'scsi' subsystem, not the 'block'
subsystem.
> You say:
>
>> ATTR{model}=3D=3D"ZIP 100"
>
> But it is 'ATTRS{model}=3D=3D"ZIP 100 "' instead.
The udev manual says that trailing whitespace is ignored.
> And besides: you cannot mix properties of two different device sections. =
> Have a
> look at how to write udev rules[0] properly.
I don't think I am mixing sections. The 'ZIP 100' string is in the 'scsi'
section.
Or am I misreading it?
Thanks
Andy
Reply to: