CTRL-D needed
The stable release of Etch has recently been
installed on an old Abit BE6 II motherboard. The
previous system run on this board was a 2.4 Sarge.
Whenever, Etch is booted, the boot stops at several
points, saying CTRL-D is needede to continue the boot.
This has not happened on the Sarge system.
Any reasons for the change in boot procedure ?
____________________________________________________________________________________
Luggage? GPS? Comic books?
Check out fitting gifts for grads at Yahoo! Search
http://search.yahoo.com/search?fr=oni_on_mail&p=graduation+gifts&cs=bz
Reply to: